Weider 831.159380 user manual Rect the problem. Important If the cables

Page 21

		47. Press two 3/4” Round Inner Caps (34) into
	ASSEMBLY	each Pad Tube (28).
	ASSEMBLY	Lever (29). Slide a Foam Foam Pad (30) onto
		Insert a Pad Tube (28) into the Front Seat
		Frame (36). Slide a Foam Pad (30) onto each
		end of the Pad Tube.
	SEAT	Insert the other Pad Tube (28) into the Leg
	SEAT	each end of the Pad Tube.
		each end of the Pad Tube.
		48. Remove the backing from the PRO 9645
		48. Remove the backing from the PRO 9645
		decal and apply it to the home gym system as
		shown.
		Make sure that all parts have been properly
		tightened. The use of the remaining parts will
		be explained in HOW TO USE THE HOME
		GYM SYSTEM, beginning on page 22 of this
		manual.
		Before using the home gym system, pull each
		cable a few times to be sure that the cables
	DECAL	move smoothly over the pulleys. If one of the
		cables does not move smoothly, find and cor-
		rect the problem. IMPORTANT: If the cables
		are not properly installed, they may be
		damaged when heavy weight is used. See

the CABLE DIAGRAMS on pages 26 and 27 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove it by tightening the cables. See TROUBLE-SHOOTING AND MAINTE- NANCE on page 25.

47

36

30

34 28

34

30

29

48

PRO 9645

21

Image 21

Contents Patent Pending Model No Serial NoSEARS, Roebuck and CO., Hoffman ESTATES, IL Important Precautions Table of ContentsUsing the Weider PRO 9645 Home Gym System Before YOU BeginFor your benefit, read this manual carefully before Frame Assembly AssemblyFollowing Tools not Included are Required for Assembly Frame AssemblyLocknuts yet Stack of Weights Stabilizer 5. Stack eight Weights ontoWeights 25 until is complete Tighten all Nylon Locknuts used in stepsBe sure that the pin on the Weight Tube is sitting in the pin grooves in the top WeightWeight Be sure that the holes in the WeightArm must be able to pivot freely Locate and open the parts bag labeled ARM AssemblyImportant for step On each Arm. Arm identification is veryDo not tighten the Nylon Locknut yet Arm with the Left Arm 47 refer to stepARM AssemblyARM Assembly Cable Assembly Long Cable Trap is positioned to hold the Cable in place Bracket Cable Cable Assembly Cable Assembly That the Pulley is on the side shown Must be inserted from the side shownThat the Cable Trap is positioned to hold Cable in placeCable Assembly Locate and open the parts bag labeled Seat Assembly Seat AssemblySeat Rect the problem. Important If the cables Are not properly installed, they may beDamaged when heavy weight is used. See Changing the Weight Setting HOW to USE the Home GYM SystemAdjusting the LEG Press Plate Attaching and Removing the SeatAttaching the LEG Lever to the LOW Pulley Station Plates Weight Resistance ChartTightening the Cables TROUBLE-SHOOTING and MaintenanceHigh Cable 58 and Low Cable Cable DiagramsHigh Cable Low CableLeg Press Cable Military Press Cable 72 and Leg Press Cable Pivot ArmPage Page X 3 1/4 Bolt R1096A Key Part Qty DescriptionKey Part Exploded DRAWING-Model No Full 90 DAY Warranty Model NoSEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL