Weider 831.159380 user manual Attaching and Removing the Seat, Adjusting the LEG Press Plate

Page 23

ATTACHING AND REMOVING THE SEAT

To attach the Seat (13), set the bracket on the Front Seat Frame (36) onto the indicated pins on the Front Upright (42). Attach the Front Seat Frame to the Front Upright with the 5/16” x 2 3/4” Carriage Bolt (14) and the Seat Knob (40).

For some exercises, the Seat (13) must be removed. First, be sure that the chain is not attached to the leg lever. Next, remove the Seat Knob (40) and the 5/16” x 2 3/4” Carriage Bolt (14) from the Seat Frame (36). Lift the Front Seat Frame off the Front Upright (42).

ATTACHING THE LEG LEVER TO THE LOW PULLEY STATION

To use the Leg Lever (29), the seat must be attached to the front upright (see ATTACHING AND REMOV- ING THE SEAT above).

Attach one end of the Chain (52) to the Short Cable

(23)with a Cable Clip (53). Attach the other end of the Chain to the Eyebolt (35) with a Cable Clip.

ADJUSTING THE LEG PRESS PLATE

Remove the Press Pin (97) from the Leg Press Plate (95) and the Leg Press Arm (96).

Align the welded tubes on the Leg Press Plate (95) with the desired set of holes in the Leg Press Arm (96). Re-insert the Press Pin (97) through the welded tubes on Leg Press Plate and the holes in the Leg Press Arm.

40	13
36

42

14

53	52	29

		35

53

23


Welded			95
Tube

97

96

23

Image 23

Contents SEARS, Roebuck and CO., Hoffman ESTATES, IL Patent PendingModel No Serial No Important Precautions Table of ContentsFor your benefit, read this manual carefully before Using the Weider PRO 9645 Home Gym SystemBefore YOU Begin Frame Assembly AssemblyFrame Assembly Following Tools not Included are Required for AssemblyLocknuts yet Tighten all Nylon Locknuts used in steps Stabilizer 5. Stack eight Weights ontoStack of Weights Weights 25 until is completeBe sure that the holes in the Weight Tube is sitting in the pin grooves in the top WeightBe sure that the pin on the Weight WeightArm must be able to pivot freely Locate and open the parts bag labeled ARM AssemblyArm with the Left Arm 47 refer to step On each Arm. Arm identification is veryImportant for step Do not tighten the Nylon Locknut yetARM AssemblyARM Assembly Cable Assembly Long Cable Trap is positioned to hold the Cable in place Bracket Cable Cable Assembly Cable Assembly Cable in place Must be inserted from the side shownThat the Pulley is on the side shown That the Cable Trap is positioned to holdCable Assembly Locate and open the parts bag labeled Seat Assembly Seat AssemblySeat Damaged when heavy weight is used. See Rect the problem. Important If the cablesAre not properly installed, they may be Changing the Weight Setting HOW to USE the Home GYM SystemAttaching the LEG Lever to the LOW Pulley Station Adjusting the LEG Press PlateAttaching and Removing the Seat Plates Weight Resistance ChartTightening the Cables TROUBLE-SHOOTING and MaintenanceLow Cable Cable DiagramsHigh Cable 58 and Low Cable High CableLeg Press Cable Military Press Cable 72 and Leg Press Cable Pivot ArmPage Page X 3 1/4 Bolt Key Part R1096AKey Part Qty Description Exploded DRAWING-Model No SEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL Full 90 DAY WarrantyModel No