Weider 831.159380 user manual Tube is sitting in the pin grooves in the top Weight

Page 7

FRAME ASSEMBLY

7.Press a Weight Tube Bumper (64) into the end of the Short Weight Tube (108). Insert the Weight Tube into the front stack of Weights (25). Be sure that the pin on the Weight

Tube is sitting in the pin grooves in the top Weight.

Lubricate the inside of the holes in a Top Weight (65). Set the Top Weight onto the front stack of Weights (25). Insert both Long Weight Guides (62) into the stack of Weights. Be sure that the holes in the Weight Guides are at the top, as shown.

8. Press a Weight Tube Bumper (64) into the

end of the Long Weight Tube (63). Insert the

Weight Tube into the rear stack of Weights

(25). Be sure that the pin on the Weight

Tube is sitting in the pin grooves in the top

Weight.

Lubricate the inside of the holes in the other

Top Weight (65). Set the Top Weight onto the

rear stack of Weights (25). Insert both Short

Weight Guides (73) into the stack of Weights.

Be sure that the holes in the Weight

7

8

Holes

62

65

Lubricate

Pin

108

64

Pin Grooves

25

Holes

73

Guides are at the top, as shown.

Lubricate

65

Pin

63

64

Pin Grooves

25

7

Image 7

Contents Model No Serial No Patent PendingSEARS, Roebuck and CO., Hoffman ESTATES, IL Important Precautions Table of ContentsBefore YOU Begin Using the Weider PRO 9645 Home Gym SystemFor your benefit, read this manual carefully before Frame Assembly AssemblyFrame Assembly Following Tools not Included are Required for AssemblyLocknuts yet Tighten all Nylon Locknuts used in steps Stabilizer 5. Stack eight Weights ontoStack of Weights Weights 25 until is completeBe sure that the holes in the Weight Tube is sitting in the pin grooves in the top WeightBe sure that the pin on the Weight WeightArm must be able to pivot freely Locate and open the parts bag labeled ARM AssemblyArm with the Left Arm 47 refer to step On each Arm. Arm identification is veryImportant for step Do not tighten the Nylon Locknut yetARM AssemblyARM Assembly Cable Assembly Long Cable Trap is positioned to hold the Cable in place Bracket Cable Cable Assembly Cable Assembly Cable in place Must be inserted from the side shownThat the Pulley is on the side shown That the Cable Trap is positioned to holdCable Assembly Locate and open the parts bag labeled Seat Assembly Seat AssemblySeat Are not properly installed, they may be Rect the problem. Important If the cablesDamaged when heavy weight is used. See Changing the Weight Setting HOW to USE the Home GYM SystemAttaching and Removing the Seat Adjusting the LEG Press PlateAttaching the LEG Lever to the LOW Pulley Station Plates Weight Resistance ChartTightening the Cables TROUBLE-SHOOTING and MaintenanceLow Cable Cable DiagramsHigh Cable 58 and Low Cable High CableLeg Press Cable Military Press Cable 72 and Leg Press Cable Pivot ArmPage Page X 3 1/4 Bolt Key Part Qty Description R1096AKey Part Exploded DRAWING-Model No Model No Full 90 DAY WarrantySEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL