ARM ASSEMBLY
15. Attach a Press Arm (7) to one side of the | 15 |
|
| |
Press Frame (12) with two 5/16” x 2 1/2” Bolts |
|
| ||
|
|
| ||
(39) and two 5/16” Nylon Locknuts (40). |
|
|
| |
Attach the other Press Arm (7) to the Press |
| 39 | 7 | |
Frame (12) in the same manner. |
|
|
| |
|
| 7 | 40 | |
|
|
| ||
|
| 12 |
| |
16. Press a 1” Round Inner Cap (70) into one of | 16 |
|
| |
the Press Arms (7). Press a 1 3/4” Square | 48 | |||
| ||||
Inner Cap (48) into the Press Arm. |
|
|
| |
Repeat this step for the other Press Arm (not |
|
| 70 | |
|
|
| ||
shown). |
|
|
| |
|
|
| 7 | |
17. Lubricate both axles on the Butterfly Frame | 17 |
|
| |
(3). |
|
| ||
|
|
| ||
Refer to the drawing and identify the Right |
|
|
| |
Arm (5) and the Left Arm (6). |
| 3 |
| |
Press a 1 3/4” Square Inner Cap (48) into the |
|
| Lubricate Axle | |
|
|
| ||
upper end of the Left Arm (6). Slide the Left |
|
|
| |
Arm onto the indicated axle. Note: Be careful |
|
|
| |
not to confuse the Left Arm with the Right | 5 | 48 |
| |
Arm (5). Be sure that the upper end of the |
| |||
|
| 45 | ||
Left Arm is behind the indicated bracket |
| Bracket | ||
on the Butterfly Frame (3). |
|
|
| |
|
|
| 46 | |
IMPORTANT NOTE: Before assembling the |
|
| 6 | |
1” Retainers (45) used in this step, be sure |
|
|
| |
that you thoroughly understand the step. |
|
|
| |
The Retainers can be assembled only once. |
|
|
| |
If they must be removed, you will need to |
|
|
| |
order new Retainers. |
|
|
| |
Tap two 1” Retainers (45) and a 1” Round |
|
|
| |
Outer Cap (46) onto the axle. Be sure that |
|
|
| |
the teeth on the Retainers bend toward the |
|
| Axle | |
Round Outer Cap, as shown in the inset |
|
| ||
|
| 45 | ||
drawing. |
|
| ||
Attach the Right Arm (5) in the same manner. |
|
| 46 | |
|
|
| ||
10