Weider WESY86301 user manual Cable Trap is turned to hold the Cable in place

Page 14

29.Find the Press Cable (88)—this is the longest Cable. Attach the end of the Press Cable (88) to the Large “U” Bracket (84) with a 1/4” Nylon Locknut (44) and a 1/4” Washer (37). Do not completely tighten the Nylon

Locknut. It should be threaded onto the end of the Cable so only a couple of threads are showing above the Nylon Locknut, as shown in the inset drawing.

30.Wrap the Press Cable (88) around a 3 1/2” Pulley (82). Attach the Pulley and a Cable Trap (80) to the indicated bracket on the Press Base (13) with a 3/8” x 2” Bolt (50) and a 3/8” Nylon Locknut (42). Be sure that the

Cable Trap is turned to hold the Cable in place.

CABLE ASSEMBLY

31.Wrap the Press Cable (88) around a 3 1/2” Pulley (82). Attach the Pulley and a Cable Trap (80) to the other bracket on the Press Base (13) with a 3/8” x 2” Bolt (50) and a 3/8” Nylon Locknut (42). Be sure that the Cable

Trap is turned to hold the Cable in place.

14

29

 

 

 

 

 

44

 

 

 

37

84

 

44

 

 

 

 

 

37

88

 

 

 

 

88

84

 

 

 

 

 

30

 

 

 

 

 

88

 

 

 

80

42

 

 

 

 

 

82

 

 

50

13

 

31

 

 

 

 

 

88

 

 

 

80

 

 

 

 

42

 

 

82

 

 

50

13

 

 

 

 

Image 14
Contents Customer HOT Line QUESTIONS?Model No. WESY86301 Serial No Table of Contents Limited WarrantyImportant Precautions For your benefit, read this manual carefully before Using the Weider 8630 Training System. If youBefore YOU Begin Following Tools not Included are Required for Assembly AssemblyFrame Assembly Frame Assembly BAG TWODo not tighten the Nylon Locknuts yet Weight Tubes are in the pin grooves in the upper Weights Nylon Locknuts yet Locate and open the parts bag labeled ARM Assembly Frame Assembly ARM AssemblyPress Plate and Adjustment Tube are ori- ented as shown Teeth on the Retainers bend toward Round Outer Cap, as shown in the inset DrawingARM Assembly Cable Assembly End with Cable Assembly Cable Trap is turned to hold the Cable in place Trap is turned to hold the Cable in placePlates 31. The Cable must be routed from Cable Trap is turned to hold the Cable PlaceBolt. Do not tighten the Nylon Jam Nut Until step Cable Trap is positioned to hold the Cable in place Cable Assembly Be sure that the Cable Trap is in the indi- cated position Seat Assembly Locate and open the parts bag labeled Seat AssemblyMisc HOW to USE the Home GYM System Changing the Weight SettingAttaching and Removing the Seat Adjusting the LEG Press PlateAttaching the AB Strap to the AB Pulley Station Attaching the LEG Lever to the LOW Pulley StationWeight Resistance Chart PlatesTROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagrams High Cable High Pulley-1 Weight Stack-5 Rear Cable Top Frame Part Identification CHART-Model No. WESY86301 R0899B Page Page Part LIST-Model No. WESY86301 Qty DescriptionExploded DRAWING-Model No. WESY86301 R0899B Ordering Replacement Parts