Weider user manual Part Identification CHART-Model No. WESY86301 R0899B

Page 28

PART IDENTIFICATION CHART—Model No. WESY86301 R0899B

1/4" Washer (37)

5/16" x 1" Bolt (97)

5/16" Washer (20)

1" Retainer (45)

5/16" x 1 3/4" Bolt (68)

 

 

 

3/8" x 2" Bolt (50)

3/8" Washer (38)

5/16" x 2 1/4" Bolt (62)

1/4" Nylon Locknut (44)

5/16" Nylon Locknut (40)

5/16" x 2 1/2" Bolt (39)

 

5/16" Nylon Jam Nut (91)

3/8" x 2 1/2" Bolt (65)–1

3/8" Nylon Locknut (42)

5/16" x 2 3/4" Bolt (55)

3/8" Nylon Jam Nut (43)

5/16" x 3" Bolt (92)

1" Tap Screw (72)

3/8" x 3 1/4" Bolt (71)

1/4" x 1/2" Screw (59)

3/8" x 3 1/2" Bolt (66)

Image 28
Contents Model No. WESY86301 Serial No QUESTIONS?Customer HOT Line Table of Contents Limited WarrantyImportant Precautions Before YOU Begin Using the Weider 8630 Training System. If youFor your benefit, read this manual carefully before Assembly Frame AssemblyFollowing Tools not Included are Required for Assembly Frame Assembly BAG TWODo not tighten the Nylon Locknuts yet Weight Tubes are in the pin grooves in the upper Weights Nylon Locknuts yet Press Plate and Adjustment Tube are ori- ented as shown Frame Assembly ARM AssemblyLocate and open the parts bag labeled ARM Assembly Teeth on the Retainers bend toward Round Outer Cap, as shown in the inset DrawingARM Assembly Cable Assembly End with Cable Assembly Cable Trap is turned to hold the Cable in place Trap is turned to hold the Cable in placePlates 31. The Cable must be routed from Cable Trap is turned to hold the Cable PlaceBolt. Do not tighten the Nylon Jam Nut Until step Cable Trap is positioned to hold the Cable in place Cable Assembly Be sure that the Cable Trap is in the indi- cated position Seat Assembly Locate and open the parts bag labeled Seat AssemblyMisc HOW to USE the Home GYM System Changing the Weight SettingAdjusting the LEG Press Plate Attaching the AB Strap to the AB Pulley StationAttaching and Removing the Seat Attaching the LEG Lever to the LOW Pulley StationWeight Resistance Chart PlatesTROUBLE-SHOOTING and Maintenance Tightening the CablesCable Diagrams High Cable High Pulley-1 Weight Stack-5 Rear Cable Top Frame Part Identification CHART-Model No. WESY86301 R0899B Page Page Part LIST-Model No. WESY86301 Qty DescriptionExploded DRAWING-Model No. WESY86301 R0899B Ordering Replacement Parts