CABLE ASSEMBLY
44.Locate the remaining preassembled pair of Pulley Plates (31) and 3 1/2” Pulleys (82).
Route the High Cable (85) under the indicated 3 1/2” Pulley (82). The end of the Pulley Plates (31) with two holes should be down- ward. Refer to the inset drawing. Be sure that the Cable is between the Cable Trap
(80)and the Pulley, and that the Cable Trap is positioned to hold the Cable in place.
Tighten the 3/8” x 2” Bolt (50) and the 3/8” Nylon Locknut (not shown).
45.Wrap the High Cable (85) around a 3 1/2” Pulley (82). Attach the Pulley to the Top Frame (2) with a 3/8” x 2” Bolt (50) and a 3/8” Nylon Locknut (42). The Cable must be routed from the direction shown.
46.Attach the High Cable (85) to a Small “U” Bracket (32) with a 1/4” Nylon Locknut (44) and a 1/4” Washer (37). Do not completely tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing.
Attach the Small “U” Bracket (32) to the indi- cated Weight Tube (25) with a 5/16” x 1 3/4” Bolt (68) and a 5/16” Nylon Locknut (40).
47.Lay the Low Cable (86) over a 3 1/2” Pulley
(82).Attach the Pulley and both Pulley Covers
(94)to the Ab Upright (1) with the 3/8” x 4” Bolt (95), two 3/8” Washers (38), and a 3/8” Nylon Locknut (42). Do not overtighten the
Nylon Locknut; the Pulley should turn eas- ily. Make sure that the Cable is between the Pulley and the post, and that the Pulley Covers are turned so the wide tabs are on the indicated side.
44 |
|
|
85 |
| 85 |
50 |
| 82 |
|
| |
31 |
| 80 |
|
| |
End with two |
|
|
holes should |
|
|
be down |
|
|
45 |
|
|
| 42 |
|
2 |
| 50 |
|
| |
|
| 82 |
|
| 85 |
46 |
| 85 |
|
| |
| 32 | 40 |
|
| |
| 68 | 37 |
|
| |
|
| 44 |
85 |
| 25 |
32 |
|
|
37 |
|
|
44 |
|
|
47 |
|
|
42 | 82 Post |
|
38 |
|
|
94 |
| 95 |
86 |
| |
Wide Tabs | 38 | |
must be on |
| |
this side |
|
|
| 1 |
|
18