Weider WESY86301 user manual Be sure that the Cable Trap is in the indi- cated position

CABLE ASSEMBLY

48.Wrap the Low Cable (86) around a 3 1/2” Pulley (82). Attach the Pulley and a Cable Trap (80) to the Ab Upright (1) with the 3/8” x 3 3/4” Bolt (76) and a 3/8” Nylon Locknut (42).

Be sure that the Cable Trap is in the indi- cated position.

49.Remove the indicated 3/8” x 2” Bolt (50), the 3/8” Nylon Locknut (42), the 3 1/2” Pulley (82), and the Cable Trap (80) from the indicat- ed Pulley Plates (31). Lay the Low Cable (86) over the Pulley. Reattach the Pulley and the Cable Trap to the lowest hole in the Pulley Plates with the Bolt and the Nylon Locknut.

Make sure that the Cable Trap is turned to hold the Cable in place.

50.Wrap the Low Cable (86) around a 3 1/2” Pulley (82). Attach the Pulley to the Ab Upright (1) with the 3/8” x 3 1/2” Bolt (66), a 3/8” Washer (38), and a 3/8” Nylon Locknut (42). The ball on the Cable must be on the indicated side of the Pulley. Be sure that the Cable and Pulley move smoothly and that the Cable is between the Pulley and the post.

19

48
	1
42	86
80
	82
	76
49
	31
	42
	50
	82
	80
86
50
	86
1
42
38	82
	66
	Post