Weider WESY86301 user manual Weight Tubes are in the pin grooves in the upper Weights

Page 7

5.Insert two Weight Guides (23) into one of the brackets on the Weight Base (14). Attach the lower ends of the Weight Guides with a 5/16” x 6” Bolt (67), two 1/2” x 3/4” Spacers (69), and a 5/16” Nylon Locknut (40). Do not over- tighten the Nylon Locknut.

Attach the other Weight Guides (23) in the same manner.

6.Slide a Weight Bumper (27) onto each of the Weight Guides (23).

Slide eight Weights (90) onto each set of Weight Guides (23). Be sure that the pin grooves are on the indicated side of each stack of Weights.

FRAME ASSEMBLY

7.Press a Weight Tube Bumper (26) into each Weight Tube (25).

Insert a Weight Tube (25) into each stack of Weights (90). Be sure that the pins on the

Weight Tubes are in the pin grooves in the upper Weights.

7

5

 

 

 

 

 

23

 

23

 

 

 

40

 

 

 

14

69

 

67

6

 

 

 

 

 

 

90

 

 

 

Pin

 

 

 

Grooves

90

 

 

 

Pin

 

 

27

Grooves

 

 

 

27

 

 

 

 

 

23

23

 

 

 

7

 

 

 

 

 

25

 

 

 

26

 

90

 

 

90

 

 

 

Image 7
Contents Model No. WESY86301 Serial No QUESTIONS?Customer HOT Line Limited Warranty Table of ContentsImportant Precautions Before YOU Begin Using the Weider 8630 Training System. If youFor your benefit, read this manual carefully before Frame Assembly BAG TWO AssemblyFrame Assembly Following Tools not Included are Required for AssemblyDo not tighten the Nylon Locknuts yet Weight Tubes are in the pin grooves in the upper Weights Nylon Locknuts yet Press Plate and Adjustment Tube are ori- ented as shown Frame Assembly ARM AssemblyLocate and open the parts bag labeled ARM Assembly Round Outer Cap, as shown in the inset Drawing Teeth on the Retainers bend towardARM Assembly Cable Assembly End with Cable Assembly Trap is turned to hold the Cable in place Cable Trap is turned to hold the Cable in placeCable Trap is turned to hold the Cable Place Plates 31. The Cable must be routed fromBolt. Do not tighten the Nylon Jam Nut Until step Cable Trap is positioned to hold the Cable in place Cable Assembly Be sure that the Cable Trap is in the indi- cated position Locate and open the parts bag labeled Seat Assembly Seat AssemblyMisc Changing the Weight Setting HOW to USE the Home GYM SystemAttaching the LEG Lever to the LOW Pulley Station Adjusting the LEG Press PlateAttaching the AB Strap to the AB Pulley Station Attaching and Removing the SeatPlates Weight Resistance ChartTightening the Cables TROUBLE-SHOOTING and MaintenanceCable Diagrams High Cable High Pulley-1 Weight Stack-5 Rear Cable Top Frame Part Identification CHART-Model No. WESY86301 R0899B Page Page Qty Description Part LIST-Model No. WESY86301Exploded DRAWING-Model No. WESY86301 R0899B Ordering Replacement Parts