CABLE ASSEMBLY
SEAT ASSEMBLY
29.Attach the Long Cable (23) to the Small “U”- Bracket (67) with a 1/4” Nylon Locknut (2)
and a 1/4” Flat Washer (10). Do not com-
pletely tighten the Nylon Locknut. It should be threaded onto the end of the Cable only a couple of turns, as shown in the inset drawing.
Attach the Small
Weight Tube (63) with the 5/16” x 1 3/4” Bolt (72) and a 5/16” Nylon Locknut (3).
30.Attach the Backrest (41) to the Front Upright
(42)with two 1/4” x 2 1/2” Screws (43) and two 1/4” Flat Washers (10).
31.Insert the 1/4” x 2 1/2” Carriage Bolt (38) into the center hole in the Seat Plate (37). Attach
the Seat Plate to the Seat (13) with two 1/4” x 1/2” Screws (18).
Insert the 1/4” x 2 1/2” Carriage Bolt (38) into the indicated hole in the Seat Frame (36).
Tighten a 1/4” Nylon Locknut (2) with a 1/4” Flat Washer (10) onto the Carriage Bolt.
Attach the other end of the Seat (13) to the Seat Frame (36) with a 1/4” Flat Washer (10) and the 1/4” x 2 1/4” Screw (24).
29
23
67
72 3 
63
10
2
23
10
2
67
30 | 42 |
41
43 10
31
13
38 |
36 37 |
18 |
10 |
24 |
2
14