Weider WESY85201 user manual Parafusode5/16x13/4

Page 22

Arruela Plana de 1/4”

Arruela Plana de 5/16” (8)–8

Arruela Plana de 3/8”

(9)–5

Parafuso de 1/4” x 1/2” (18)–2

Parafuso de 1/4” x 2 1/4” (24)–1

Parafuso de 1/4” x 2 1/2” (43)–2

Pino de 5/16” x 5” (68)–1

Parafusode5/16”x13/4” (72)–1

Parafuso de 5/16” x 2 1/2” (22)–5

Parafuso de 5/16” x 2 3/4” (11)–6

Pino de Montagem 5/16” x 2 1/2”

(1)–4

Pino de Montagem de 5/16” x 2 3/4” (14)–2

Pino de Montagem de 1/4” x 2 1/2” (38)–1

Pino de 5/16” x 6” (60)–1

Image 22
Contents Customer HOT Line QUESTIONS?Model No. WESY85201 Serial No Mon.-Fri., 6 a.m.-6 p.m. MSTTable of Contents Limited WarrantyIng down Important PrecautionsMake sure that the cables remain on the pul Using the Weider Before YOU BeginFollowing Tools not Included are Required for Assembly AssemblyAssembly, use the Part Identification Not tighten the Nylon Locknuts yetEach Carriage Bolt Frame AssemblyTighten all Nylon Locknuts used in steps 1 through Frame Assembly ARM Assembly ShownAttach a V-Pulley 6 and a Long Cable Trap On each Arm. Arm identification is very important for stepAttach the Left Arm 47 in the same manner Nylon Locknuts until the end of this assembly step Tighten all Nylon Locknuts used in this step nowA 3/8 Nylon Locknut Cable AssemblyLocate the Long Cable Cable in placeBracket. Note This may come pre-assem- bled Pulley 6 on the Right Arm Be sure3/8 x 2 1/2 Bolt 7 and the 3/8 Nylon Locknut not shown For easy part identificationFront Upright Locate the Short Cable Route3/8 x 3 1/2 Bolt 16 Trap 66 is turned to hold the CableTighten the 3/8 Nylon Locknut 21 and the 3/8 x 3 1/2 Bolt A 1/4 Flat Washer 10. Do not com Cable Assembly Seat AssemblySeat Plate to the Seat 13 with two 1/4 x 1/2 Screws Insert the L-Pin 40 through the holes Seat Assembly Decal Placement8520 Amount of resistance at each weight station AdjustmentChanging the Weight Setting Attaching the LAT BAR or Nylon Strap to High Pulley StationWeight Resistance Chart Locking the LEG LeverWoven cable, the type of cable used on the home TROUBLE-SHOOTING and MaintenanceTightening the Cables That the Cable and Pulley move smoothlyShort Cable Cable DiagramCable traps do not touch or bind the cables Long Cable Be sure thatOrdering Replacement Parts Part No R1096ARemove this Part Identification Chart from the Manual WESY85201 R1096AParafusode5/16x13/4 Clipe do Cabo Espaçador de 1/2 x 3/4 61-2 Remove this Part LIST/EXPLODED Drawing from the Manual Part LIST-Model No. WESY85201 Qty DescriptionR1096A