Miele wt945 Indicator lamp flashes, During a programme, But the wash, Programme has run, Normally

Problem solving guide

A fault indicator lamp comes on but the wash programme continues as normal.

Problem	Possible cause	Remedy
The Water inlet/drain	There is a blockage in	Check whether:
indicator lamp flashes	the water inlet.	– the stopcock is opened
during a programme,		wide enough.
but the wash		– the inlet hose is kinked.
programme has run
	The water pressure is	– In this case, call the Miele
normally.
	too low.	Service Dept.
	The filter in the water	– Clean the filter as described
	inlet hose is dirty.	in "Cleaning and care".
The Water inlet/drain	There is a blockage in	– Clean the fluff filter and the
indicator lamp is	the water outlet.	drain pump.
flashing.		– Has the drain hose been
		fitted too high? Max.
		delivery head, 1.00 m
The Drying overload	The load was too	– In future do not exceed the
indicator lamp is	large.	maximum load. This way
flashing towards the		you will avoid:
end of a drying		a) Creasing of
programme.		delicate textiles
		b) Uneven drying
		results / damp laundry
		Complete the drying process
		using a TIMED DRYING
		programme.
The Anti-crease/Finish	The selected	See section "Safety Lock".
indicator lamp is	programme was
flashing and the	altered with the safety
locked indicator lamp	lock activated.
is on.

46