Miele WT 945 S WPS, wt945 Before using for the first time, Flushing out the drum

Page 13

Before using for the first time

Before using the machine for the first time ensure that it is correctly installed and connected. See the relevant section under "Installation".

Flushing out the drum

^Turn on the stopcock.

^Turn both programme selectors to the Finish position.

^Switch the machine on with the I-ON /0-OFFbutton.

Do not load any laundry.

^Add max. 1/4 of the amount of detergent recommended for a full load into Compartment j of the detergent dispenser.

^Turn the WASHING programme selector to the "COTTONS 60°C" position.

Important! This programme is required to prepare the machine for operation.

^Press the Water plus button.

^Press the "Spin" button repeatedly until the Without final spin indicator lamp comes on.

^Press the START button.

This will flush out any residues in the machine by the end of the programme.

Water hardness reminder

The amount of detergent required will depend on various factors, including water hardness. The dial in the detergent dispenser can be set as a water hardness reminder.

There is a yellow lever behind the detergent drawer facia panel.

^Remove the lever.

^Use it to turn the dial to the position which represents your water hardness level.

Your local water authority can advise on water hardness in your area.

13

Image 13
Contents Operating instructions Washer-dryer WT 945 S WPS Contents Contents Consumption data Technical data Disposal of the packing material Caring for the environmentDisposal of your old appliance or machine Correct usage Technical safetyUse Disposal of your old machine Using accessoriesDescription of the appliance FeaturesStart button Control panelDoor button Opens the drum door On / 0-OFF button Additional option buttonsSpin button with indicator lamps Important control panel featuresProgramme selector Washing and drying environmentally Flushing out the drum Before using for the first timeWater hardness reminder Cottons e Programme overviewMinimum Iron e f Woollens g Delicates fQuick wash Drain / Spin StarchSeparate rinse Flushing out the drumHow to wash correctly Important other care symbols How to wash correctlyTumble dry IroningBefore washing Separate washingSort the laundry Select a programme Soak Detergent dispensing when selecting the soak optionPre-wash Water plusAdding detergent At the end of a programme Door cannot be opened, if Adding and removing laundryCottons Programme cycleQuick Wash Special features in the programme sequencesDetergent Adding detergentWater softener Washing with several componentsFabric conditioners, texturisers and starch Fabric conditioners / starch formulationsAdding fabric conditioner or liquid starch separately Separate starchingFollowing fabrics should not be tumble dried Tips on dryingProgramme overview Always select the Drying / Low temp. option Timed Drying 20 min / 30 min / 40 min / 60 minBefore drying Separate dryingPreparing the laundry Select a drying programme Programme selectionDrying / Low temp After drying Close the drum door Open the stopcock Add detergent Washing and drying in a continuous sequenceSelect the programme After each washing or drying programme Rinse out fluff programme To cancel an incorrectly selected programme To cancel a programmeChanging a programme sequence To change a programme which has been lockedSafety lock Safety lockEngaging the safety lock Cleaning the machine Cleaning and careCleaning the detergent dispenser ClothClean the siphon tube Clean the porthole glassCleaning the filter in the water inlet What to do if ... ? Problem solving guideDept Programme does not startWash programme stops and a fault indicator light comes on Locked indicator lamp Indicator lamp flashesDuring a programme But the washGeneral problems or an unsatisfactory wash or drying result Opened during or after OptionDrying When washing Problem Possible cause Remedy Laundry is stillWhen drying separately Damp after a dryingSpun satisfactorily Problem Possible cause Remedy Laundry is notMachine is not Steady during a spinBuild-up of foam Problem Possible cause Remedy There is an excessiveWhite residues which Look like powderNot give the required Problem Possible cause Remedy Liquid detergent doesResult Remember to removeBlocked drain outlet Opening the drum door Appliance guarantee After sales serviceFront view Installation and connectionInstallation Installation surfacePlease note the following Removing the transit fitting Levelling the machine Screwing out and adjusting the feetInstallation and connection Miele Waterproof system Electronic unit and washing machine housingInlet hose Drain hoseConnection to the water supply Installation and connection Maintenance and care Drain hose connection Connection to the drainage systemElectrical connection U.K Non-rewireable plugs BSProgrammes Consumption dataTechnical data Programmable functions for changing standard settings High water level Programmable functionsAdditional rinse for Cottons programme Buzzer Opening the door at high temperatures Final residual moisture after drying Factory settingShortening the drying time Lengthening the drying timePage Alteration rights reserved / 3404 / WT 945 S