Miele WT 945 S WPS, wt945 operating instructions Use

Page 7

Warning and Safety instructions

The Miele "Waterproof system" protects from water damage

provided the following conditions have been met:

the machine is correctly plumbed in and connected to the electricity supply.

if a fault has been identified, the machine must be examined by a competent person before further use, and repaired if necessary.

Faulty components must only be exchanged for Miele original spare

parts. Only when these parts are fitted can the safety standards of the machine be guaranteed.

If the connection cable is faulty it must only be replaced by a Miele approved service technician to protect

the user from danger.

In countries where there are areas which may be subject to infestation

by cockroaches or other vermin, pay particular attention to keeping the appliance and its surroundings in a clean condition at all times. Any damage which may be caused by cockroaches or other vermin will not be covered by the appliance guarantee.

Use

This equipment is not designed for maritime use or for use in mobile

installations such as caravans, aircraft etc. However it may be suitable for such usage subject to a risk assessment of the installation being carried out by a suitably qualified engineer.

Take care, the metal cap is hot after drying. Open the door wide

after the drying cycle. Do not touch the metal cap located on the inside of the door glass. It will still be hot and could cause a burn.

Do not install your machine in rooms where temperatures below

freezing may occur. Frozen hoses may burst under pressure.The reliability of the electronic control unit may be impaired at temperatures below freezing point.

Before using the machine for the first time, check that the transit

fitting at the rear of the machine has been removed (see section on "Installation"). During spinning, a transit fitting which is still in place may result in damage to both the machine and adjacent furniture or appliances.

Turn off the stopcock if the machine is to be left for any length of time

(e.g. holiday), especially if there is no floor drain (gully) in the immediate vicinity.

Flooding danger. If hooking the drain hose into a wash basin, check that

the water can drain off quickly enough to prevent the sink from overflowing. Make sure the drain hose is secure, so that the force of the water flowing out of the hose does not dislodge it.

Take care to ensure that foreign objects (e.g. nails, pins, coins,

paper clips) do not find their way into the machine with the laundry. These may damage components of the machine (e.g. suds container, drum), which in turn can result in damage to the laundry.

7

Image 7
Contents Operating instructions Washer-dryer WT 945 S WPS Contents Contents Consumption data Technical data Disposal of the packing material Caring for the environmentDisposal of your old appliance or machine Correct usage Technical safetyUse Disposal of your old machine Using accessoriesDescription of the appliance FeaturesAdditional option buttons Control panelStart button Door button Opens the drum door On / 0-OFF buttonSpin button with indicator lamps Important control panel featuresProgramme selector Washing and drying environmentally Flushing out the drum Before using for the first timeWater hardness reminder Cottons e Programme overviewMinimum Iron e f Woollens g Delicates fQuick wash Flushing out the drum StarchDrain / Spin Separate rinseHow to wash correctly Ironing How to wash correctlyImportant other care symbols Tumble dryBefore washing Separate washingSort the laundry Select a programme Water plus Detergent dispensing when selecting the soak optionSoak Pre-washAdding detergent At the end of a programme Door cannot be opened, if Adding and removing laundryCottons Programme cycleQuick Wash Special features in the programme sequencesWashing with several components Adding detergentDetergent Water softenerSeparate starching Fabric conditioners / starch formulationsFabric conditioners, texturisers and starch Adding fabric conditioner or liquid starch separatelyFollowing fabrics should not be tumble dried Tips on dryingProgramme overview Always select the Drying / Low temp. option Timed Drying 20 min / 30 min / 40 min / 60 minBefore drying Separate dryingPreparing the laundry Select a drying programme Programme selectionDrying / Low temp After drying Close the drum door Open the stopcock Add detergent Washing and drying in a continuous sequenceSelect the programme After each washing or drying programme Rinse out fluff programme To change a programme which has been locked To cancel a programmeTo cancel an incorrectly selected programme Changing a programme sequenceSafety lock Safety lockEngaging the safety lock Cloth Cleaning and careCleaning the machine Cleaning the detergent dispenserClean the siphon tube Clean the porthole glassCleaning the filter in the water inlet What to do if ... ? Problem solving guideDept Programme does not startWash programme stops and a fault indicator light comes on But the wash Indicator lamp flashesLocked indicator lamp During a programmeGeneral problems or an unsatisfactory wash or drying result Opened during or after OptionDrying Damp after a drying Problem Possible cause Remedy Laundry is stillWhen washing When drying separatelySteady during a spin Problem Possible cause Remedy Laundry is notSpun satisfactorily Machine is notLook like powder Problem Possible cause Remedy There is an excessiveBuild-up of foam White residues whichRemember to remove Problem Possible cause Remedy Liquid detergent doesNot give the required ResultBlocked drain outlet Opening the drum door Appliance guarantee After sales serviceFront view Installation and connectionInstallation Installation surfacePlease note the following Removing the transit fitting Levelling the machine Screwing out and adjusting the feetInstallation and connection Drain hose Electronic unit and washing machine housingMiele Waterproof system Inlet hoseConnection to the water supply Installation and connection Maintenance and care Drain hose connection Connection to the drainage systemElectrical connection U.K Non-rewireable plugs BSProgrammes Consumption dataTechnical data Programmable functions for changing standard settings High water level Programmable functionsAdditional rinse for Cottons programme Buzzer Opening the door at high temperatures Lengthening the drying time Factory settingFinal residual moisture after drying Shortening the drying timePage Alteration rights reserved / 3404 / WT 945 S