Miele T 8822 C operating instructions Garment care label symbols, Tips on drying, Drying, Ironing

Page 11

Notes on laundry care

Garment care label symbols

Drying

￿Normal/higher temperature

￿Reduced temperature: Select Low temperature (for delicate textiles)

￿Do not tumble dry

Ironing

￿Very hot

￿Hot

￿Warm

￿Do not iron

Tips on drying

Always observe the maximum recommended loads given in the "Programme chart". Never overload the drum.

Overloading can cause unnecessary wear and tear to the laundry, give a disappointing drying result and cause more creasing.

Do not put soaking wet items into the tumble dryer. Spin fabrics for at least 30 seconds before drying.

Open jackets so that they can dry evenly.

Use the Automatic plus programme for drying mixed loads of cotton and minimum iron fabrics.

Woollens and wool blends tend to become matted and shrink if dried in a tumble dryer. They can, however, be "fluffed up" using the Woollens handcare programme.

Down-filled garments have linings which have a tendency to shrink, depending on the quality of the item. They can be partially dried using the Gentle smoothing programme.

Pure linen should only be machine dried if specified as suitable by the manufacturer on the care label, as the surface of the fabric may otherwise become rough.

Loopknit garments (e.g. T-shirts and underwear) tend to shrink depending on their quality. Do not over-dry these textiles. When purchasing these garments it is advisable to take their shrinkage properties into account.

Minimum iron fabrics tend to crease more, the larger the load. This is also the case for garments made from very fine weave fabrics, such as shirts or blouses.

If in doubt, divide the garments into smaller loads.

Starched laundry can be dried in the tumble dryer. To achieve the usual finish, double the amount of starch should be used.

New dark coloured garments should be washed and dried separately from light coloured garments to avoid the danger of colours running and discolouring other garments or even plastic components in the dryer. Dark coloured fibres can also settle on light coloured garments and vice versa.

11

Image 11
Contents Operating instructions For condenser tumble dryer T 8822 C Energy saving tips Caring for the environmentDisposal of the packing material Disposal of your old applianceContents Contents Correct application Safety with childrenTechnical safety Correct use Accessories Control panel Operating the tumble dryerFollowing are also selected via the display Programme duration / Estimated time remainingDisplay shows Ironing Garment care label symbolsTips on drying DryingTurn on the tumble dryer How to dry correctlyBrief instructions Sort the laundryDrying level programmes Select any Extra options / Delay startSelect a programme Before the end of a programme Remove the laundry when the programme has finishedStart the programme Extra options Extra options / Delay startDelay start Delicates Max. load 2.5 kg Normal, Hand iron Programme chartCottons Max. load 7 kg Extra dry, Normal Hand iron**, Machine ironManufacturer as being suitable for use on membrane Woollens handcare Max. load 2 kgProofing Max. load 2.5 kg Normal Only use proofing agents which are stated byGentle smoothing Max. load 1 kg Shirts Max. load 2 kg Normal, Hand ironCool air Max. load 7 kg Warm air Max. load 7 kgAdding or removing laundry after a programme has started Altering Delay startChanging the programme sequence Once a programme has startedTo deactivate the lock Electronic system lockTo activate the lock Emptying the condensed water container Cleaning and careCleaning them whilst dry Cleaning the fluff filtersCleaning them with water Cleaning the tumble dryer Removing the condenser unit Cleaning the condenser unitChecking the condenser unit Checking and cleaning the condenser unit housing Check and fault messages Problem solving guideBuzzer sounds To switch off the indicator Light Problem Possible cause RemedyAirways indicator To switch off the indicatorProgrammes do not Indicators for theseCool air programmes Will not startAn unsatisfactory drying result Goes on too long or Other problemsProblem Possible cause Remedy Drying process Even switches offDryer after Problem Possible cause Remedy Water leaks fromBeen cleaned Power cutChanging the lamp Optional accessories After Sales serviceFuture updates PC Appliance guaranteeFront view InstallationReplacing the lid Installation siteTransporting the dryer to its installation site Rear viewWasher-dryer stack Before moving the tumble dryer again e.g. when moving houseLevelling the appliance Room ventilationArranging the drain hose External condensed water outletGeneral notes External drainage via a sink or gully Installation conditions requiring a non-return valveInstallation Electrical connection U.K Non-rewireable plugs BSElectrical connection Woollens handcare Consumption dataTechnical data Extending the range of the drying levels Programmable functionsHours anti-crease Anti-crease settingAnti-crease deactivated Hour anti-crease Normal buzzer Default setting Loud buzzer Altering the volume of the buzzerMemory function Memory deactivated default setting Memory activatedCooling down time will be ten minutes longer Extending the cooling down timeFollow steps to to programme and store in memory Default setting Clean out airways indicatorKeypad tone Default setting Adjusted for very soft water Adjusting the dryers electronics for very soft waterPage Page Page Alteration rights reserved/1409 Nr 483 560
Related manuals
Manual 64 pages 59 Kb