How to dry correctly
Start the programme
The Start/Stop button will flash when a programme is being selected. The flashing indicates that a programme can be started.
Press the Start/Stop button.
The Start/Stop button will now light up constantly.
*Drying will appear in the display and the Perfect Dry indicator will flash.
The indicator will go out after approx. 1 minute and the estimated programme duration will appear in the display.
Note: The duration shown in the display is an estimate and can vary.
Before the end of a programme
* The Perfect Dry indicator will light up.
There is a cooling down phase at the end of the drying sequence (Cooling down will appear in the display). The programme will not finish until the cooling down phase has been completed.
There is no cooling down phase at the end of the Woollens handcare programme.
*Only with programmes with drying levels (exception: Gentle smoothing).
Remove the laundry when the programme has finished
0 and Finish will appear in the display to indicate that the programme has finished. The buzzer (if selected) will sound at intervals.
The drum will continue to rotate at intervals for up to two hours to prevent laundry creasing, if you do not wish to remove it immediately
Press the Door button.
Open the door.
Remove the laundry.
Check that all items have been removed from the drum. If items are left in the dryer, they could be damaged by overdrying when the dryer is next used.
If the dryer is switched on at the mains and the door is opened, the drum lighting will come on. It will go out a few minutes later to save energy.
Switch the dryer off by pressing the button.
Clean the fluff filters.
Close the door.
Empty the condensed water container (unless the dryer has been connected for external drainage).
The condenser unit should be checked and cleaned on a regular basis (see "Cleaning and care").
14