Miele T 8822 C Rear view, Installation site, Transporting the dryer to its installation site

Page 37

Installation

Rear view

Protruding lid for holding when moving the dryer (see arrows)

Air inlet vent for cooling the condenser unit

Mains connection cable

Hose for external drainage of condensed water

Accessories for connection to a sink drain outlet

Installation site

Make sure the dryer door can be opened without hindrance after installation.

Transporting the dryer to its installation site

When moving the dryer, hold it by the lid where it protrudes to the rear. To manoeuvre the dryer out of its packing case to its installation site you will also need to hold it by the front feet.

Building under a continous worktop / in a kitchen run

A building-under kit* with a coverplate to replace the appliance lid is required. It must be fitted by a suitably qualified person to ensure electrical safety.

N.B. If you wish to push your appliance under a worktop and there is space to do this without removing the lid the building-under kit is not necessary. Otherwise it is essential.

–The building-under kit is supplied with its own installation instructions.

–N.B. When built-under drying times may be longer.

–The electrical socket must be located in an accessible position near the appliance.

With niche heights of:

–830-840 mm, longer screw feet* are required.

–870-885 / 915-930 mm, one or two raising kits* are required.

* Miele accessory available to order

Replacing the lid

If the lid has been removed in order to fit a coverplate, ensure that, if the lid is ever replaced, it fits securely into the rear holders. Otherwise, it is not properly secure for transport.

37

Image 37

Contents Operating instructions For condenser tumble dryer T 8822 C Disposal of the packing material Caring for the environmentDisposal of your old appliance Energy saving tipsContents Contents Correct application Safety with childrenTechnical safety Correct use Accessories Control panel Operating the tumble dryerDisplay shows Programme duration / Estimated time remainingFollowing are also selected via the display Tips on drying Garment care label symbolsDrying IroningBrief instructions How to dry correctlySort the laundry Turn on the tumble dryerSelect a programme Select any Extra options / Delay startDrying level programmes Start the programme Remove the laundry when the programme has finishedBefore the end of a programme Delay start Extra options / Delay startExtra options Cottons Max. load 7 kg Extra dry, Normal Programme chartHand iron**, Machine iron Delicates Max. load 2.5 kg Normal, Hand ironProofing Max. load 2.5 kg Normal Woollens handcare Max. load 2 kgOnly use proofing agents which are stated by Manufacturer as being suitable for use on membraneCool air Max. load 7 kg Shirts Max. load 2 kg Normal, Hand ironWarm air Max. load 7 kg Gentle smoothing Max. load 1 kgChanging the programme sequence Altering Delay startOnce a programme has started Adding or removing laundry after a programme has startedTo activate the lock Electronic system lockTo deactivate the lock Emptying the condensed water container Cleaning and careCleaning them whilst dry Cleaning the fluff filtersCleaning them with water Cleaning the tumble dryer Removing the condenser unit Cleaning the condenser unitChecking the condenser unit Checking and cleaning the condenser unit housing Check and fault messages Problem solving guideAirways indicator Problem Possible cause RemedyTo switch off the indicator Buzzer sounds To switch off the indicator LightCool air programmes Indicators for theseWill not start Programmes do notAn unsatisfactory drying result Problem Possible cause Remedy Drying process Other problemsEven switches off Goes on too long orBeen cleaned Problem Possible cause Remedy Water leaks fromPower cut Dryer after Changing the lamp Future updates PC After Sales serviceAppliance guarantee Optional accessoriesFront view InstallationTransporting the dryer to its installation site Installation siteRear view Replacing the lidLevelling the appliance Before moving the tumble dryer again e.g. when moving houseRoom ventilation Washer-dryer stackGeneral notes External condensed water outletArranging the drain hose External drainage via a sink or gully Installation conditions requiring a non-return valveInstallation Electrical connection Non-rewireable plugs BSElectrical connection U.K Woollens handcare Consumption dataTechnical data Extending the range of the drying levels Programmable functionsAnti-crease deactivated Hour anti-crease Anti-crease settingHours anti-crease Normal buzzer Default setting Loud buzzer Altering the volume of the buzzerMemory function Memory deactivated default setting Memory activatedFollow steps to to programme and store in memory Extending the cooling down timeCooling down time will be ten minutes longer Default setting Clean out airways indicatorKeypad tone Default setting Adjusted for very soft water Adjusting the dryers electronics for very soft waterPage Page Page Alteration rights reserved/1409 Nr 483 560

Related manuals

Manual 64 pages 59 Kb