Miele T 8822 C operating instructions Problem solving guide, Check and fault messages

Problem solving guide

With the help of the following notes, minor faults in the performance of the appliance, some of which may result from incorrect operation, can be put right without contacting the Service Department.

￿Repair work to electrical appliances should only be carried out by a suitably qualified person in strict accordance with current local and national safety regulations. Repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work.

Check and fault messages

Problem	Possible cause	Remedy
The programme stops	This is not a fault.	– Use the Warm air
and 0 and Finish appear	The electronic unit has	programme (timed
in the display.	recognised that there is	drying) to dry individual
The buzzer sounds.	no laundry in the drum	items.
	and cancelled the	– To select a new
	programme.	programme, switch the
	Drying individual	dryer off and on, or
	garments or items which	– Open the door, place
	are already dry can also	more laundry in the
	cause the programme to	drum, then close the
	be cancelled.	door.
The Low temperature	The electronic system	You will need to
indicator light starts	lock is activated.	deactivate the system
flashing after the dryer		lock before the dryer can
has been switched on		be used (see "Electronic
and 0-§appears in the		system lock").
display.
The programme stops	No obvious cause.	– Switch the dryer off
and Cooling down or		and then on again.
Finish flashes in the		– Then start the
display.		programme again.
The buzzer sounds.		If the programme stops
		again and Cooling down
		or Finish flashes again,
		there is a fault. Contact
		the Miele Service
		Department.

28