Miele T 8822 C operating instructions Cleaning the condenser unit, Removing the condenser unit

Page 25

Cleaning and care

Cleaning the condenser unit

Detergent residue, hair and fine fluff from the dryer can get through the fluff filters and block the condenser unit. Dust from the room in which the dryer is installed can also get into the condenser unit and cause a blockage.

Check the condenser unit at least twice a year. Always check it if the Clean out airways indicator light comes on. If the dryer is used frequently then check the condenser unit after approx. 100 drying cycles. Clean it if necessary.

Removing the condenser unit

￿Open the service panel. Hold the panel securely when doing this.

￿Now remove the panel by pulling it diagonally upwards and place it to one side.

￿Turn the lever on the inner cover downwards to the vertical position.

￿Tilt the cover forwards.

￿Remove it by pulling it diagonally upwards.

￿Turn the lever on the condenser unit upwards to the vertical position so that the hook on the lever is no longer in the groove at the bottom of the condenser unit housing.

25

Image 25
Contents Operating instructions For condenser tumble dryer T 8822 C Disposal of the packing material Caring for the environmentDisposal of your old appliance Energy saving tipsContents Contents Correct application Safety with childrenTechnical safety Correct use Accessories Control panel Operating the tumble dryerDisplay shows Programme duration / Estimated time remainingFollowing are also selected via the display Tips on drying Garment care label symbolsDrying IroningBrief instructions How to dry correctlySort the laundry Turn on the tumble dryerSelect a programme Select any Extra options / Delay startDrying level programmes Start the programme Remove the laundry when the programme has finishedBefore the end of a programme Delay start Extra options / Delay startExtra options Cottons Max. load 7 kg Extra dry, Normal Programme chartHand iron**, Machine iron Delicates Max. load 2.5 kg Normal, Hand ironProofing Max. load 2.5 kg Normal Woollens handcare Max. load 2 kgOnly use proofing agents which are stated by Manufacturer as being suitable for use on membraneCool air Max. load 7 kg Shirts Max. load 2 kg Normal, Hand ironWarm air Max. load 7 kg Gentle smoothing Max. load 1 kgChanging the programme sequence Altering Delay startOnce a programme has started Adding or removing laundry after a programme has startedTo activate the lock Electronic system lockTo deactivate the lock Emptying the condensed water container Cleaning and care Cleaning them whilst dry Cleaning the fluff filtersCleaning them with water Cleaning the tumble dryer Removing the condenser unit Cleaning the condenser unitChecking the condenser unit Checking and cleaning the condenser unit housing Check and fault messages Problem solving guideAirways indicator Problem Possible cause RemedyTo switch off the indicator Buzzer sounds To switch off the indicator LightCool air programmes Indicators for theseWill not start Programmes do notAn unsatisfactory drying result Problem Possible cause Remedy Drying process Other problemsEven switches off Goes on too long orBeen cleaned Problem Possible cause Remedy Water leaks fromPower cut Dryer afterChanging the lamp Future updates PC After Sales serviceAppliance guarantee Optional accessoriesFront view InstallationTransporting the dryer to its installation site Installation siteRear view Replacing the lidLevelling the appliance Before moving the tumble dryer again e.g. when moving houseRoom ventilation Washer-dryer stackGeneral notes External condensed water outletArranging the drain hose External drainage via a sink or gully Installation conditions requiring a non-return valveInstallation Electrical connection Non-rewireable plugs BSElectrical connection U.K Woollens handcare Consumption dataTechnical data Extending the range of the drying levels Programmable functionsAnti-crease deactivated Hour anti-crease Anti-crease settingHours anti-crease Normal buzzer Default setting Loud buzzer Altering the volume of the buzzerMemory function Memory deactivated default setting Memory activatedFollow steps to to programme and store in memory Extending the cooling down timeCooling down time will be ten minutes longer Default setting Clean out airways indicatorKeypad tone Default setting Adjusted for very soft water Adjusting the dryers electronics for very soft waterPage Page Page Alteration rights reserved/1409 Nr 483 560
Related manuals
Manual 64 pages 59 Kb