73
WFL 2060 & WFR 2460 Service TipsTips --
- Troubleshooting (1)
Symptom |
| Problem |
|
| Solution | |
|
|
|
|
| ||
Washer won’t start. | | Electricity is disconnected | | Make sure washer is connected to an appropriate 240V, 60 Hz | ||
|
| or has been turned off. |
| circuit (according to local codes). Turn on electricity. | ||
| | Cycle | selector knob | or | | Control module has onboard cycle selector knob. Check |
|
| control module has failed. |
| voltage output to water inlet valves and drum motor (when | ||
|
|
|
|
|
| they’re energized). If no voltage, replace faulty control module. |
Washer won’t fill. | | Water supply turned off. | | Turn on water supply. | ||
| | Water | inlet hose filters | | Check water inlet hose filters. Clean if dirty. Replace filters if | |
|
| (strainers) blocked. |
|
| damaged. | |
| | Water pressure too low. | | Check incoming water pressure. | ||
| | Control | module | has | | Check voltage output to water inlet valves (when they’re |
|
| failed. |
|
|
| energized). If no voltage, replace faulty control module. |
| | Water | inlet valve(s) | has | | Measure resistance of water inlet valves (~ 2.7 – 4.5 kΩ). |
|
| failed. |
|
|
| Replace inlet valve(s), if faulty. |
Washer won’t drain. | | Drain pump or motor | | Disconnect drain pump and measure resistance at connector | ||
|
| protector has failed. |
|
| (~ 80 – 94 Ω). Replace drain pump if faulty. | |
| | Control | module | has | | Check voltage output to drain pump when it’s energized). If no |
|
| failed. |
|
|
| voltage, replace faulty control module. |
WARNING! Unplug washer before starting any repairs.
1st Edition/Revision 5 (1/20/04)