75
|
|
|
|
|
|
|
|
| Tips |
| WFL 2060 & WFR 2460 Service Tips | ||||||||
|
|
|
|
|
| Troubleshooting (3) | |||
|
|
|
|
|
|
| |||
| Symptom |
| Problem |
|
| Solution | |||
|
|
|
|
|
|
| |||
| Washer overheats. | | Control | module has | | Check voltage to heater. If voltage is present when heater | |||
|
|
|
|
| failed. |
|
|
| shouldn’t be on, replace faulty control module. |
|
|
|
| | NTC failed. |
| | Disconnect NTC and measure resistance at terminals (~ 5.4 – | |
|
|
|
|
|
|
|
|
| 6.5 kΩ @ 20ºC (68ºF)). Replace NTC if faulty. |
| Door won’t lock. | | Door | isn’t | closed | | Close door securely. If door won’t latch, check door latch and | ||
|
|
|
|
| properly. |
|
| door hinge alignment. | |
|
|
|
| | Door latch is broken. | | Replace broken door latch. | ||
|
|
|
| | Door lock has failed. | | Measure resistance of door lock mechanism (~ 500 – 1500 Ω for | ||
|
|
|
|
|
|
|
|
| WFL 2060 or 211 – 259 Ω for WFR 2460). Replace faulty door |
|
|
|
|
|
|
|
|
| lock mechanism. |
|
|
|
|
|
|
| |||
| Washer | won’t spin | | Replacement control | | Use test T5 on test program (pp. 43, 61) to configure control | |||
| over | 800 | RPM |
| module |
| wasn’t |
| module to U.S. settings (42010011). |
| (WFR 2460). |
|
| configured | when |
|
| ||
|
|
|
|
| installed. |
|
|
| |
| Washer | has | wrong | | Replacement control | | Use instructions on page 42 to set dipswitches on control | ||
| wash cycles and hot |
| module |
| wasn’t |
| module (p.c. board) to U.S. settings. | ||
| water inlet | doesn’t |
| configured | when |
|
| ||
| work (WFL 2060). |
| installed. |
|
|
|
WARNING! Unplug washer before starting any repairs.
1st Edition/Revision 5 (1/20/04)