Bosch Appliances WFR2460UC, WFL 2060UC manual Operation --WFR 2460UC Sales Demo Modeode

25

Operation --WFR 2460UC Sales Demo Modeode

CAUTION: To avoid danger of electrical shock, make sure the washer is unplugged before changing any electrical connections!

IMPORTANT: When reselling any WFL2060 or WFR2460 washers from display floors, replace the white (or gray) drain pump connector so washers will run properly and replace the shipping bolts so washers won’t be damaged during shipment.

SALES DEMO MODE PROCEDURE: Preparing WFR2460 washers for display involves removing three shipping bolts and disconnecting the drain pump. To set up WFR2460 washers for display:

Conversion: Make sure the washer is unplugged and is not connected to any water lines.

1.Remove the three shipping bolts from the washer back panel, removing the top bolt last. Each bolt has an insert wedging up to the inside of the back panel. When removing bolts, loosen them, then move them (up, left or right) until they slide out the large circular holes (matching the insert sizes). Don’t unscrew shipping bolts completely so inserts won’t drop into the washer base. After removing bolts, cover the holes with white caps included with the washer.

2.To access the white (or gray) drain pump connector from the back of the washer, remove the back panel by removing (7) T-20 & (4) T-30 Torx screws. Pull the white (or gray) drain pump connector to remove it, then secure the loose connector away from the frame or any washer parts with electrical tape (to avoid possibility of electrical shock).

3.Replace the back panel, then attach the fuscia label to the rear of the washer so its visible.

Power hook-up:Plug the washer into a 120V/240V transformer, then plug the transformer into a 120V, 15A power outlet.

Using demo mode: Rotate the cycle selector knob to the “Spin” position and then push the “Start” button to perform a complete spin cycle. To interrupt the spin cycle, push the “Start/Pause” button.

HINT: Before starting, make sure you have the following:

9B120V/240V transformer

9Fuscia demo mode label (“IMPORTANT”)

9Access to 120V, 15A, 60Hz electrical outlet

9T-20 & T-30 Torx screwdrivers

9Electrical tape

NOTE: Do not connect WFL2060 washers for sales demonstration -- all lights will turn on and washers won’t run.

IMPORTANT

Shipping bolt locations

Suggested placement for fuscia label

(“IMPORTANT”)

WFR2460 drain pump is located at washer right front corner (photo viewing rear of washer)

Pull off white (or gray) drain pump electrical connector

1st Edition/Revision 5 (1/20/04)