74
|
|
|
|
|
| Tips |
WFL 2060 & WFR 2460 Service Tips | ||||||
|
|
| Troubleshooting (2) | |||
|
|
|
|
|
| |
| Symptom |
| Problem |
| Solution | |
|
|
|
|
|
| |
| Drum won’t rotate. | | Drum rear bearing | | Check how drum rotates. If drum wobbles or won’t move, | |
|
|
| has failed. |
|
| replace faulty rear bearing. |
|
| | Motor drive circuit | | Check voltage at motor connectors when motor is energized. | |
|
|
| (Triac) has failed. |
| If low or no voltage, replace faulty control module. | |
|
| | Drum drive motor | | Check voltage at motor connectors when motor is energized. | |
|
|
| has failed. |
|
| If ~ 240V, replace faulty drum motor. |
|
| | Reversing | relays | | Check voltage at motor connectors when motor is energized. |
|
|
| have failed. |
| If voltage doesn’t reverse, replace faulty control module. | |
| Washer won’t heat. | | Heater has failed. | | Disconnect heater and measure resistance at terminals (~ | |
|
|
|
|
|
| 23.2 – 29.4Ω). Replace heater if faulty. |
|
| | NTC has failed. | | Disconnect NTC and measure resistance at terminals (~ 5.4 | |
|
|
|
|
|
| – 6.5 k Ω @ 20ºC (68ºF)). Replace NTC if faulty. |
|
| | Heater is covered | | If possible, remove & clean heater. If not, replace it. | |
|
|
| with scale. |
|
|
|
|
| | Voltage too low. | | Have an electrician check the house wiring and the wiring to | |
|
| | Control | module |
| the washer to make sure it is 240 volts. |
|
|
| Check voltage output to drain pump when it’s energized). If | |||
|
|
| has failed. |
| | |
|
|
|
|
|
| no voltage, replace faulty control module. |
WARNING! Unplug washer before starting any repairs.
1st Edition/Revision 5 (1/20/04)