54
WFL 2060 Service Tips -- Test Programram (3)(3)
To enter comprehensive test program for WFL 2060 washers (to test entire washer or check last
wash fault):
♦ Rotate cycle selector knob to Off position and rotate spin speed knob to 1000 RPM.
♦ Push and hold Start button (or Rinse Plus and Quick Wash buttons at the same time), then rotate cycle selector knob cw to Power Temp Boost position. After rotating cycle selector knob, keep holding Start button (or Rinse Plus and Quick Wash buttons) at least 3 seconds until Door locked & Rinse/Spin lights come on. Washer is now in the comprehensive test program.
♦ Lights will flash for wash faults
♦ When test program has been entered:
Door locked
♦ Door locked & Rinse/Spin lights will come on (and stay on). Rinse/Spin
♦ See chart on 5th test program page for test sequence.
Wash
♦ Test ends automatically (after ~ 2 minutes, 20 seconds when Door locked & Rinse/Spin lights come on) and automatically restarts. To end test (at any time), rotate cycle selector knob out of Power Temp Boost position (to any position). If a fault has occurred during test, check fault chart to determine failed part.
NOTE: Fault displayed will be 1st fault that occurred since last time washer was turned on.
NOTE: Do not push Start button (or Rinse Plus & Quick Wash buttons) within 5 seconds of rotating cycle selector knob to Power Temp Boost position while selecting comprehensive test program or while test is restarting. If so, individual part (component) test program will begin
1st Edition/Revision 5 (1/20/04)