Alliance Laundry Systems 55, 75, 40, 33 Mechanical Installation, Important Drawing is not to scale

Page 29

Installation

Mechanical Installation

Frame Dimensions and Mounting Bolt

Location

	18, 25, 35, 55, 75, 100, 135 and 165 Pound
	Capacity with U in the 8th position of the
	Model Number (e.g. *X18PVXU6)
	26 in.
	(660 mm)
	23.38 in.
	(594 mm)
	1.81 in.	20.87 in.
	1.81 in.	(530 mm)
	(30 mm)
	23.23 in.	1.3 in.
	(590 mm)	1.3 in.
	(590 mm)	(33 mm)
		(33 mm)
	22.59 in.
	(650 mm)	2.56 in.
		2.56 in.
		(65 mm)
	1.81 in.	CFD42N
	(30 mm)	CFD42N
	(30 mm)
	18 MODEL
		CFD42N

Figure 14

IMPORTANT: Drawing is not to scale.

9001000

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

27

Image 29

Contents Washer-Extractors Page Contents Important Safety Instructions Explanation of Safety MessagesSafety Information Safety Decals Operator Safety Model Identification Introduction100 135 165 200 Introduction Nameplate Location Replacement PartsCustomer Service 0001 Introduction Model Number Familiarization GuideWeight and Shipping Information General Specifications Model Overall DimensionsWash Cylinder Information Door Opening InformationCentrifugal Force Data Cylinder SpeedsBalance Detection Direct Steam Heating OptionalWeight and Shipping Information RPM Specifications and Dimensions Main Switch Electrical Power Inputs Flushing Supply Dispenser Steam Connection Input Optional 88 mm 220 mm Mm 53.07 in mm 50 mm 34 mm Model 1168 mm 1575 mm 33.6 1010 mm 305 mm 360 mm 56.5 mm Recommended Minimum Clearances Model 100 135 165 200 InstallationFloor Load Data Model 100 135 165 200 InstallationImportant Drawing is not to scale Mechanical InstallationPound 34 mm 22 mm 26.18 665 mm 26.77 50 mm 680 mm 30.71 780 mm 712 mm 34 mm 22 mm 30.12 765 mm 898 mm 42.52 47.24 1200 mm 40 mm 1200 mm 42.5 mm 1300 mm 33 mm 44.8 660 mm 55 mm 30.31 782 mm 45 mm Mounting Bolt Installation If Required Removing the Transport Brackets Front Rear 40 Models Rear of Machine Drain ConnectionMinimum Drain ID Model Number of Machines Model 100 135 165 200Water Supply Information Model 100 135 165 200 Water ConnectionDo not use a phase adder on any variable- speed machine Electrical InstallationCycle Phase Wire Full Load Amps Installation Remote Liquid Supply Connection Electrical ConnectionSteam Supply Information 18-75 100/135 165/200 Steam Requirements Steam Heat Option OnlySupply Programming Table Example Pumps 24V ~ Automatic Lubricator Out-of-Balance SwitchMachine Control Function Test