Alliance Laundry Systems 200, 75, 40, 33, 100, 135, 165, 18, 55 manual Operator Safety

Page 7

Operator Safety

WARNING

NEVER insert hands or objects into basket until it has completely stopped. Doing so could result in serious injury.

SW012

To ensure the safety of machine operators, the following maintenance checks must be performed daily:

1.Prior to operating the machine, verify that all warning signs are present and legible. Missing or illegible signs must be replaced immediately. Make certain that spares are available.

2.Check door interlock before starting operation of the machine:

a.Attempt to start the machine with the door open. The machine should not start with the door open.

b.Close the door without locking it and attempt to start the machine. The machine should not start with the door unlocked.

c.Close and lock the door and start a cycle. Attempt to open the door while the cycle is in progress. The door should not open.

If the door lock and interlock are not functioning properly, call a service technician.

3.Do not attempt to operate the machine if any of the following conditions are present:

a.The door does not remain securely locked during the entire cycle.

b.Excessively high water level is evident.

c.Machine is not connected to a properly grounded circuit.

Safety Information

Do not bypass any safety devices in the machine.

WARNING

Never operate the machine with a bypassed or disconnected balance system. Operating the machine with severe out-of-balance loads could result in personal injury and serious equipment damage.

SW039

9001000

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

5

Image 7

Contents Washer-Extractors Page Contents Important Safety Instructions Explanation of Safety MessagesSafety Information Safety Decals Operator Safety Model Identification Introduction100 135 165 200 Introduction Customer Service Replacement PartsNameplate Location 0001 Introduction Model Number Familiarization GuideDoor Opening Information General Specifications Model Overall DimensionsWeight and Shipping Information Wash Cylinder InformationDirect Steam Heating Optional Cylinder SpeedsCentrifugal Force Data Balance DetectionWeight and Shipping Information RPM Specifications and Dimensions Main Switch Electrical Power Inputs Flushing Supply Dispenser Steam Connection Input Optional 88 mm 220 mm Mm 53.07 in mm 50 mm 34 mm Model 1168 mm 1575 mm 33.6 1010 mm 305 mm 360 mm 56.5 mm Recommended Minimum Clearances Model 100 135 165 200 InstallationFloor Load Data Model 100 135 165 200 InstallationImportant Drawing is not to scale Mechanical InstallationPound 34 mm 22 mm 26.18 665 mm 26.77 50 mm 680 mm 30.71 780 mm 712 mm 34 mm 22 mm 30.12 765 mm 898 mm 42.52 47.24 1200 mm 40 mm 1200 mm 42.5 mm 1300 mm 33 mm 44.8 660 mm 55 mm 30.31 782 mm 45 mm Mounting Bolt Installation If Required Removing the Transport Brackets Front Rear 40 Models Rear of Machine Drain ConnectionMinimum Drain ID Model Number of Machines Model 100 135 165 200Water Supply Information Model 100 135 165 200 Water ConnectionDo not use a phase adder on any variable- speed machine Electrical InstallationCycle Phase Wire Full Load Amps Installation Remote Liquid Supply Connection Electrical ConnectionSteam Supply Information 18-75 100/135 165/200 Steam Requirements Steam Heat Option OnlySupply Programming Table Example Pumps 24V ~ Automatic Lubricator Out-of-Balance SwitchMachine Control Function Test