Alliance Laundry Systems 100, 75, 40, 33, 135, 165, 200, 18, 55 manual Contents

Page 3

Table of

Contents

Safety Information	2
Explanation of Safety Messages	2
Important Safety Instructions	2
Safety Decals	4
Operator Safety	5
Introduction	6
Model Identification	6
Nameplate Location	8
Replacement Parts	8
Customer Service	8
Specifications and Dimensions	10
Installation	25
Dimensional Clearances	25
Machine Foundation	26
Mechanical Installation	27
Frame Dimensions and Mounting Bolt Location	27
Mounting Bolt Installation (If Required)	41
Removing the Transport Brackets	42
Drain Connection	44
Water Connection	46
Electrical Installation	47
Electrical Connection	50
Remote Liquid Supply Connection	50
Chemical Injection Supply System	50
Steam Requirements (Steam Heat Option Only)	51
Supply Programming Table	52
Supply Relay Configuration (No Wiring)	52
Primary 220 Volt Remote Liquid Supply Connection	52
Out-of-Balance Switch	54
Automatic Lubricator	54
Control Function Test	55

© Copyright 2010, Alliance Laundry Systems LLC

All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher.

9001000

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

1

Image 3

Contents Washer-Extractors Page Contents Important Safety Instructions Explanation of Safety MessagesSafety Information Safety Decals Operator Safety Model Identification Introduction100 135 165 200 Introduction Replacement Parts Customer ServiceNameplate Location 0001 Introduction Model Number Familiarization GuideDoor Opening Information General Specifications Model Overall DimensionsWeight and Shipping Information Wash Cylinder InformationDirect Steam Heating Optional Cylinder SpeedsCentrifugal Force Data Balance DetectionWeight and Shipping Information RPM Specifications and Dimensions Main Switch Electrical Power Inputs Flushing Supply Dispenser Steam Connection Input Optional 88 mm 220 mm Mm 53.07 in mm 50 mm 34 mm Model 1168 mm 1575 mm 33.6 1010 mm 305 mm 360 mm 56.5 mm Recommended Minimum Clearances Model 100 135 165 200 InstallationFloor Load Data Model 100 135 165 200 InstallationImportant Drawing is not to scale Mechanical InstallationPound 34 mm 22 mm 26.18 665 mm 26.77 50 mm 680 mm 30.71 780 mm 712 mm 34 mm 22 mm 30.12 765 mm 898 mm 42.52 47.24 1200 mm 40 mm 1200 mm 42.5 mm 1300 mm 33 mm 44.8 660 mm 55 mm 30.31 782 mm 45 mm Mounting Bolt Installation If Required Removing the Transport Brackets Front Rear 40 Models Rear of Machine Drain ConnectionMinimum Drain ID Model Number of Machines Model 100 135 165 200Water Supply Information Model 100 135 165 200 Water ConnectionDo not use a phase adder on any variable- speed machine Electrical InstallationCycle Phase Wire Full Load Amps Installation Remote Liquid Supply Connection Electrical ConnectionSteam Supply Information 18-75 100/135 165/200 Steam Requirements Steam Heat Option OnlySupply Programming Table Example Pumps 24V ~ Automatic Lubricator Out-of-Balance SwitchMachine Control Function Test