Alliance Laundry Systems 135, 75, 40, 33, 100, 165, 200, 18, 55 manual Removing the Transport Brackets

Page 44

Installation

Removing the Transport Brackets

To prevent damage during transportation, the machine has been equipped with four red transport brackets (refer to Figure 29 for 18, 25 and 35 models; refer to Figure 30 for 33 and 40 models; refer to Figure 31 for 55 and 75 models [depending on model number]; refer to Figure 32 for 100, 135, 165 and 200 models) to eliminate every possible movement of the tub.

After the machine has been placed level, take off the service panels and the back panel to remove these transport brackets.

WARNING

The machine must never be activated before removing these transport brackets.

W489

1 CFD34NCFD34N

18, 25 AND 35 MODELS WITH A OR M IN THE 8TH

POSITION IN THE MODEL NUMBER

(E. G. *X18PVXM6)

1	CFD65N
	CFD65N

18, 25 AND 35 MODELS WITH U IN THE 8TH

POSITION IN THE MODEL NUMBER

(E. G. *X18PVXU6)

1Transport Brackets

Figure 29

42

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

9001000

Image 44

Contents Washer-Extractors Page Contents Explanation of Safety Messages Important Safety InstructionsSafety Information Safety Decals Operator Safety Introduction Model Identification100 135 165 200 Introduction Nameplate Location Replacement PartsCustomer Service Introduction Model Number Familiarization Guide 0001General Specifications Model Overall Dimensions Weight and Shipping InformationWash Cylinder Information Door Opening InformationCylinder Speeds Centrifugal Force DataBalance Detection Direct Steam Heating OptionalWeight and Shipping Information RPM Specifications and Dimensions Main Switch Electrical Power Inputs Flushing Supply Dispenser Steam Connection Input Optional 88 mm 220 mm Mm 53.07 in mm 50 mm 34 mm Model 1168 mm 1575 mm 33.6 1010 mm 305 mm 360 mm 56.5 mm Installation Recommended Minimum Clearances Model 100 135 165 200Installation Floor Load Data Model 100 135 165 200Mechanical Installation Important Drawing is not to scalePound 34 mm 22 mm 26.18 665 mm 26.77 50 mm 680 mm 30.71 780 mm 712 mm 34 mm 22 mm 30.12 765 mm 898 mm 42.52 47.24 1200 mm 40 mm 1200 mm 42.5 mm 1300 mm 33 mm 44.8 660 mm 55 mm 30.31 782 mm 45 mm Mounting Bolt Installation If Required Removing the Transport Brackets Front Rear 40 Models Drain Connection Rear of MachineModel 100 135 165 200 Minimum Drain ID Model Number of MachinesWater Connection Water Supply Information Model 100 135 165 200Electrical Installation Do not use a phase adder on any variable- speed machineCycle Phase Wire Full Load Amps Installation Electrical Connection Remote Liquid Supply ConnectionSteam Requirements Steam Heat Option Only Steam Supply Information 18-75 100/135 165/200Supply Programming Table Example Pumps 24V ~ Out-of-Balance Switch Automatic LubricatorControl Function Test Machine