Changing Pre-Set Options
Option Adjustment Mode
After using your Ecosmart you may want to fine tune some of the options to suit your wash needs.
You can change the following
the amount of water used in the Shower Rinse the number of beeps at the end of the cycle the Out of Balance recovery routine
the fill level selected by auto water level the controlled cold
To make these changes it is necessary to enter the “Option Adjustment Mode”.
To enter Option Adjustment Mode
1. Plug the machine in, but do not press POWER.
Press START / PAUSE and hold down, then press POWER.
2.You will hear three quick beeps and the machine will
show an unusual pattern of lights. In this mode the lights are used to indicate the different options available. The diagram on page 27 shows how the lights relate to the options you can change.
Pages 28 – 29 explain the different options in more detail.
3.Use the buttons on the panel to make your changes to the
4.Press POWER to return to normal mode.
5. Your Ecosmart will automatically remember your changes.
6. To make further changes, repeat the above steps.
26