22
Changing pre-set options
Option adjustment mode
After using your Smart Drive™ you may want to fine tune some of the options to suit your wash needs.
There are a number of
In the EXCELLENCE model the following
The RINSE option on HEAVY DUTY and REGULAR cycles. The COLD wash to CONTROLLED COLD.
The number of beeps at the end of the cycle. The fill level selected by AUTO water level. The out of balance recovery routine.
In the PRIDE model the following
The WARM wash temperature.
The RINSE option on HEAVY DUTY, REGULAR and WOOL cycles.
The out of balance recovery routine.
To enter option adjustment mode
1Turn machine on at the wall but do not press POWER. Press START/PAUSE and hold down, then press POWER. You will hear two quick beeps and the machine will show an unusual pattern of lights.
In this mode the lights are used to indicate the different options available.
The diagram on page 23 shows how the lights relate to the options you can change.
Pages 24 – 26 explain the different options in more detail.
2Use the buttons on the panel to make your changes to the
3Press POWER to return to normal mode.
4Your Smart Drive™ will automatically remember your changes.
EXCELLENCE
Fig.25 Entering Option Adjustment mode
Note: while EXCELLENCE model is shown, setting of the PRIDE model is identical
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 22 | 8/10/09 2:45:26 PM |