2
Installation instructions
Unpacking
To ensure the best performance from your new
Smart Drive™ please follow the instructions below.
Removing the packaging
1Remove the outer packaging.
2Tilt the machine backwards and walk it off the bottom packer one foot at a time.
3Remove the bottom packer from under the machine by pulling it out the front.
4Lift the lid and remove the bowl packer from the bowl.
5 | Remove the hoses and accessories. |
|
|
|
6 | Keep the bottom packer and bowl packer in case they |
|
|
|
|
|
| ||
| are required for future transit. | Fig.1 Tilt washer backwards to remove packer | ||
Important!
Please ensure that the bottom packer has been removed before operating your machine.
Location
Your washer must be installed on a level surface, and not on any textured floor coverings (eg carpet, rugs) to ensure that the opening at the bottom of the machine is not obstructed.
In your clothes washer you will find:
4 rubber inserts for the levelling feet (joined together). 1 hose guide.
2 inlet hoses.
Drain hose
1Carefully pull the drain hose out from the back of the machine by pulling the exposed part of the hose downward and outward.
2To guide the drain hose over the tub or standpipe the hose guide MUST be fitted to the drain hose.
To prevent syphoning:
The drain hose should not extend more than 20 mm from the end of the guide.
The height of the standpipe or tub should be between 850 – 1200 mm.
The drain hose can be trimmed to length.
3Place the drain hose in the tub or standpipe.
Pull hose 
through guide
| (20 mm) |
| maximum |
| 850 – 1200 mm |
Flex hose | Standpipe |
| |
guide apart |
|
Fig.2 Fitting the drain hose guide | |
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 2 | 8/10/09 2:45:22 PM |