Fisher & Paykel 4323 If your Smart Drive beeps for help, LID Lock light is flashing

Page 34

If your Smart Drive™ beeps for help

LID LOCK light is flashing.

Make sure the lid is closed.

Press START/PAUSE (refer to page 10).

If the symptom persists call your Fisher & Paykel Dealer or Authorised Repairer.

First RINSE or SPIN progress light is flashing as well as the SPIN SPEED light.

Wash load is out of balance. Ensure the machine is stationary. Manually redistribute the load. Check the machine is level (refer to page 3).

Single beep every second and... possible solutions

Some lights are on but the pattern of lights is unfamiliar.

1Turn your machine off at the wall,

2Wait for 60 seconds and turn it back on.

3Check the machine is level (refer to page 3).

4Remove load and retry.

5Put through a deep RINSE and SPIN.

6If the fault re-occurs repeat Step 1.

If the machine still will not work call your Fisher & Paykel Dealer or Authorised Repairer to arrange service (refer to page 37).

4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 32

8/10/09 2:45:28 PM

Image 34

Contents Installation instructions Intelligence working for you Contents Location Installation instructionsUnpacking Drain hoseCold supply only Inlet hosesLevelling To check if your machine is levelWater supply Clothes washer safetyAccessories and spare parts DrainingGetting started Before you do your first washDetergent Using your Excellence washerFabric softener Wash options PowerWash cycles AdvanceUsing your Pride washer Pride WA55T56MW1 MW512 Fabric softenerIf you wish to stop your Pride washer Lid lock LID Lock lightModel variations Default settingsBasic cycle descriptions To select the wash options Clothes care safeguardsWash options and advancing the cycle Wash progress lightsAuto water level Water levelsManual water level selection Excellence model onlyQuick wash Wash options saving water and timeExcellence and Pride model Soak Delay StartWash options Nappy sanitisers/bleachWashing bulky items Washing woollensTo set your favourite cycle Favourite cycleFavourite cycle To use your favourite cycleCustomising the wash cycles To customise a cycleLoading Before you washSorting Lint givers Lint collectorsHow much detergent? DetergentChoosing the right detergent Adding the detergentHow the fabric softener is dispensed Cleaning the dispenserFabric softener How much fabric softener?To enter option adjustment mode Option adjustment modeChanging pre-set options Use the buttons on the panel to change the pre-set options Rinse options Wash temperaturesDefault MED spin light onAuto water fill level Controlled coldEnd of cycle beeps Light on OptionSpecifications Out of balance recovery routineMachine information Cleaning the inside of your Smart Drive When you have finishedCleaning your Smart Drive Cold water washingSmart Drive sounds and beeps Products that might damage your Smart DriveAutomatic lint system Recycling the wash water Saving waterRecycling the water from a deep rinse Manual suds save with syphon back Return Hose to DrainHOT and Cold water temperature lights are flashing HOT water temperature light is flashingCold water temperature light is flashing High water level light is flashingLID Lock light is flashing Single beep every second and... possible solutionsIf your Smart Drive beeps for help Some lights are on but the pattern of lights is unfamiliarOperating problems Wash problems Dye transfer TanglingFisher & Paykel undertakes to Manufacturer’s WarrantyThis warranty does not cover Please keep this User Guide in a safe placeNew Zealand if you need assistance Before you call for service or assistance…Customer Care Australia if you need assistanceNZ AU PAC