Fisher & Paykel 4323 When you have finished, Cold water washing, Cleaning your Smart Drive

Page 29

Machine information

When you have finished

Turn off the taps to prevent the chance of flooding should a hose burst.

Turn off the power at the wall.

Cold water washing

If you always use cold water, we recommend that a WARM or HOT wash be used at regular intervals, eg every 5th wash should be at least a warm one.

Cleaning your Smart Drive

Clean with a soft damp cloth and wipe dry. Do not use

 

scouring cleaners as they can damage the paint, plastic

 

and panel surfaces.

 

Clean the fabric softener dispenser after each cycle using

 

warm soapy water.

 

You can remove the lid for cleaning. Open the lid fully,

 

hold one side with one hand and gently tap the other side

 

with an upward motion.

 

To replace the lid, hold the lid vertically and align both

 

hinges before pushing down firmly.

 

To remove the agitator for cleaning, unscrew the nut

Fig.32 Removing the lid

down the centre of the agitator by turning anti-clockwise.

 

27

Important!

The agitator must be fully pushed onto the shaft when refitting. Tighten the nut firmly by hand. Ensure the agitator is not loose.

Cleaning the inside of your Smart Drive

If you use fabric softener or do regular cold water washing, it is important that you occasionally clean the inside of your machine.

Fill your machine with hot water. Add about two cups of a powdered detergent. Let it agitate for 10 – 15 minutes.

Stop the machine (press START/PAUSE), open the lid and leave it to soak overnight. After soaking, drain the machine (advance to SPIN) and then run the machine through a REGULAR cycle.

We do not recommend that you wash clothes during this procedure.

4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 27

8/10/09 2:45:28 PM

Image 29
Contents Installation instructions Intelligence working for you Contents Unpacking Installation instructionsLocation Drain hoseLevelling Inlet hosesCold supply only To check if your machine is levelAccessories and spare parts Clothes washer safetyWater supply DrainingBefore you do your first wash Getting startedFabric softener Using your Excellence washerDetergent Wash cycles PowerWash options AdvancePride WA55T56MW1 MW512 Fabric softener Using your Pride washerIf you wish to stop your Pride washer LID Lock light Lid lockBasic cycle descriptions Default settingsModel variations Wash options and advancing the cycle Clothes care safeguardsTo select the wash options Wash progress lightsManual water level selection Water levelsAuto water level Excellence model onlyExcellence and Pride model Wash options saving water and timeQuick wash Wash options Delay StartSoak Nappy sanitisers/bleachWashing woollens Washing bulky itemsFavourite cycle Favourite cycleTo set your favourite cycle To use your favourite cycleTo customise a cycle Customising the wash cyclesSorting Before you washLoading Lint givers Lint collectorsChoosing the right detergent DetergentHow much detergent? Adding the detergentFabric softener Cleaning the dispenserHow the fabric softener is dispensed How much fabric softener?Changing pre-set options Option adjustment modeTo enter option adjustment mode Use the buttons on the panel to change the pre-set options Default Wash temperaturesRinse options MED spin light onEnd of cycle beeps Controlled coldAuto water fill level Light on OptionMachine information Out of balance recovery routineSpecifications Cleaning your Smart Drive When you have finishedCleaning the inside of your Smart Drive Cold water washingAutomatic lint system Products that might damage your Smart DriveSmart Drive sounds and beeps Recycling the water from a deep rinse Saving waterRecycling the wash water Return Hose to Drain Manual suds save with syphon backCold water temperature light is flashing HOT water temperature light is flashingHOT and Cold water temperature lights are flashing High water level light is flashingIf your Smart Drive beeps for help Single beep every second and... possible solutionsLID Lock light is flashing Some lights are on but the pattern of lights is unfamiliarOperating problems Wash problems Tangling Dye transferThis warranty does not cover Manufacturer’s WarrantyFisher & Paykel undertakes to Please keep this User Guide in a safe placeCustomer Care Before you call for service or assistance…New Zealand if you need assistance Australia if you need assistanceNZ AU PAC