Fisher & Paykel 4323 Machine information, Out of balance recovery routine, Specifications

Page 28

26

Changing pre-set options

Out of balance recovery routine

When your Smart Drive™ is spinning it can sense if the wash load is out of balance and will stop and re-try spinning up to three times. If it still senses an unbalanced load there are two options the machine can take.

Automatic recovery option

Your Smart Drive™ will try to automatically correct the out of balance load. It will fill with water and agitate to redistribute the load before trying to spin up again.

Machine stops option

Your Smart Drive™ will stop, give a short burst of beeps every five seconds, and the RINSE or SPIN light will flash. You must redistribute the load more evenly yourself (use this option if you wish to conserve water).

EXCELLENCE
REGULAR	REGULAR
light on	light off
= automatic recovery	= machine stops

PRIDE

REGULAR	REGULAR
light on	light off
= automatic recovery	= machine stops

Fig.31 Adjusting the Out of balance recovery routine

Machine information

Specifications

	Model	Capacity	Depth	Width	Height*	Height (lid open)

	WA75T65GW1	7.5 kg	650 mm	650 mm	1020 – 1050 mm	1410 – 1440 mm

	WA65T60GW1	6.5 kg	600 mm	600 mm	1020 – 1050 mm	1360 – 1390 mm

	WA55T56GW1	5.5 kg	560 mm	560 mm	1020 – 1050 mm	1320 – 1350 mm

	WA55T56MW1	5.5 kg	560 mm	560 mm	1020 – 1050 mm	1320 – 1350 mm
	(MW512)	5.5 kg	560 mm	560 mm	1020 – 1050 mm	1320 – 1350 mm
	(MW512)

Electrical Supply: 220 – 240 V, 50 Hz Sinusoidal, 165 W

Inlet Water Pressure: Max. 1 MPa (150 psi) Min. 34 Pa (5 psi)

Inlet Water Flow Rate: Min. 3 litres/min

Standpipe Height: 850 – 1200 mm

Note: exact height of your Smart Drive™ is dependent on how far the feet are inserted onto the base of the machine.

* Height is measured to the highest point on the console.

4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 26

8/10/09 2:45:27 PM

Image 28

Contents Installation instructions Intelligence working for you Contents Installation instructions UnpackingLocation Drain hoseInlet hoses LevellingCold supply only To check if your machine is levelClothes washer safety Accessories and spare partsWater supply DrainingGetting started Before you do your first washDetergent Using your Excellence washerFabric softener Power Wash cyclesWash options AdvanceUsing your Pride washer Pride WA55T56MW1 MW512 Fabric softenerIf you wish to stop your Pride washer Lid lock LID Lock lightModel variations Default settingsBasic cycle descriptions Clothes care safeguards Wash options and advancing the cycleTo select the wash options Wash progress lightsWater levels Manual water level selectionAuto water level Excellence model onlyQuick wash Wash options saving water and timeExcellence and Pride model Delay Start Wash optionsSoak Nappy sanitisers/bleachWashing bulky items Washing woollensFavourite cycle Favourite cycleTo set your favourite cycle To use your favourite cycleCustomising the wash cycles To customise a cycleBefore you wash SortingLoading Lint givers Lint collectorsDetergent Choosing the right detergentHow much detergent? Adding the detergentCleaning the dispenser Fabric softenerHow the fabric softener is dispensed How much fabric softener?To enter option adjustment mode Option adjustment modeChanging pre-set options Use the buttons on the panel to change the pre-set options Wash temperatures DefaultRinse options MED spin light onControlled cold End of cycle beepsAuto water fill level Light on OptionSpecifications Out of balance recovery routineMachine information When you have finished Cleaning your Smart DriveCleaning the inside of your Smart Drive Cold water washingSmart Drive sounds and beeps Products that might damage your Smart DriveAutomatic lint system Recycling the wash water Saving waterRecycling the water from a deep rinse Manual suds save with syphon back Return Hose to DrainHOT water temperature light is flashing Cold water temperature light is flashingHOT and Cold water temperature lights are flashing High water level light is flashingSingle beep every second and... possible solutions If your Smart Drive beeps for helpLID Lock light is flashing Some lights are on but the pattern of lights is unfamiliarOperating problems Wash problems Dye transfer TanglingManufacturer’s Warranty This warranty does not coverFisher & Paykel undertakes to Please keep this User Guide in a safe placeBefore you call for service or assistance… Customer CareNew Zealand if you need assistance Australia if you need assistanceNZ AU PAC