8Check the horizontality with a level (Gage).
1Step
If washing machine legs are loose or not screwed, then screw up with the spanner wrench. Using the level, level the washing machine from front to back and side to side.
A level
Higher
Tighten
Adjustable feet
2Step
Using the spanner wrench to adjust leg for horizontality and try for Diagonal test.
Diagonal test | How to perform a diagonal test: |
Place your right hand on the back, right corner and your left hand on the front, left corner of the unit, then attempt to rock the unit from corner to corner. Then, move your right hand to the front, right side and your left hand to the back, left corner and attempt to rock the unit from corner to corner.
If the unit is level, it will not rock. However, if the unit is not level, it will rock.
If the unit rocks, it will be necessary to adjust the leveling feet of the unit.
Adjust the foot under the hand that is on the front of the machine.
Higher | Lower | Lock nut |
| ||
Tighten | Tighten |
|
|
| Adjustable bolt |
Adjustable feet | Adjustable feet |
|
Lower the foot until there is no gap between floor and foot.
And only use adjustment rubber when difference at the leg adjustment is more than 10mm.
10mm
Rubber Cup
4620ER3001A
(Black)
for Tile floors
4620ER3001B
(Gray)
for Wooden floors
3Step
Perform a Rinse and Spin with some clothing in the machine.
To do this, put 2~3kg of clothing in the unit, power on the unit, press the Rinse and Spin button, and then start. When the unit reaches the spin cycle, watch for vibrations.
If the unit is vibrating, make small adjustments to the leg until they subside. (Try 2Step again)
4Step
Tighten the lock nut against the base of the machine to lock the position leg.
Tighen the lock nut 
10