F1*22TD(1~9)
LOAD TEST MODE 
Page 19
- Press and Hold ‘Temp.’ & ‘Spin’ buttons and then press ‘Power’ button.
Water level frequency
- Press and Hold ‘Temp.’ & ‘Medic Rinse’ buttons simultaneously.
LED display
•Display the estimated remaining time (Hour : Minute) to finish.
•In case of abnormal operation, error indications are displayed.
( | ) |
• See troubleshooting guide.
Spin Button
•By pressing the Spin Button the spin speed can be chosen
•F10**TD(1~9)
Rinse Hold/No spin/400/800/1000
• F12**TD(1~9)
Rinse Hold/No spin/400/800/1200
• F14**TD(1~9)
Rinse Hold/No spin/400/800/1200/1400
Time Delay & Beep ON/OFF
•Press the button when reservation washing is needed.
•When the button is pressed, [ 
] is
displayed, maximum delay of [ 
] hours can be set.
•Each press advances time delay by the hour.
•Use [Power] button to cancel [Time Delay]
•[Time Delay] means the time required from the present to the completion of washing.
•The Beep on/off function can be set by pressing and holding the Time Delay button (About 3 seconds).
The Beep on/off function can be set at any time and it is automatically cancelled in the event of a power cut.
The Beep on/off function also works when power is off.
Power button
•Press the button to turn power on and off.
•Press the button to cancel the time delay.
Water temperature selector
•Press the button to select water temperature.
•95°C is selected for Cotton and Baby Care only.
•By pressing the button while operating the washer, the present temperature is displayed.
13