LG Electronics F1256QD service manual Installation, Check the conditions of installation area

Page 8

4. INSTALLATION

INSTALLATION

The appliance should be installed as follows.

1Check the conditions of installation area.

1. Check level ground.

horizontal

On raised foundations or upper level homes, the vibrations can be caused by the type of flooring. It may be necessary to move the machine to a different area in the home or have the floor reinforced to properly support the operation of the unit.

2. Check humidity or any foreign objects under the feet.

Clean the floor, and there should not be any foreign objects under the feet.

If the unit has foreign objects underneath the feet, this will prevent the unit from being leveled properly and will cause vibrations and slipping.

Remove any foreign objects, if any from underneath the machine and level unit properly. See below for examples of foreign objects.

Purchased

stopper

Capet

Paper

Laminated

paper

2 Open the box and check appliance condition.

Washer

Base Packing

Packing Support

Wrench

This leveling (or spanner) wrench must be used to remove the shipping bolts and level the unit. This should be kept for future use.

7

Image 8

Contents Washing Machine No. MFL30574749 Contents Specification F1*20TD1~9 / F1*22TD1~9/F1*56*D/WD-*690TDKFeatures & Technical Explanation FeaturesDoor can not be Opened Determine Washing Time by Fuzzy LogicWater Level Control Door Lower cover Adjustable Feet Power PlugParts Identification DrawerInstallation InstallationCheck the conditions of installation area Open the box and check appliance conditionTap connection and hose connection must be parallel Use spanner to remove transit boltsConfirm the distance between the appliance and the wall Connect power plug Connect Drain HoseCheck the horizontality with a level Gage StepTest operation Start/Pause button Tub Clean OperationOption Wash program selectorLoad Test Mode Time Delay & Beep ON/OFFPower button Water temperature selectorStart/Pause button Option buttonIntensive Rinse Spin Button Chart MotorPCB Layout Program Chart Troubleshooting Before Performing ServiceLoad Test Mode HOW to Know the Water Level FrequencyError Display Error Symptom CauseTroubleshooting with Error Water Inlet Error IEUnbalanced Error UE Water Outlet Error OE How to disassemble and clean pump filterBind Over Flow Error FE Drawer continuously?Pressure Sensor S/W Error PE Door Open Error dE Does the Door Switch operate as follows?Thermistor Heating Error tE MIN STD MAXMotor Locked Error LE Disassemble the Hall Sensor Assemble the Hall SensorTroubleshooting Without Error Codes No PowerVibration & Noise In Spin Detergent & Softener does not flow Water Leak Water Leak from DispenserUnknown Water on Floor Disassembly Instructions Control PanelDispenser Assembly Dispenser AssemblyInlet Valve Lower Cover DoorGasket Assembly Rotor ASSEMBLY, Stator ASSEMBLY, Friction Damper Assembly CommonPump HeaterSwitch ASSEMBLY, Door Lock When Foreign Material is Stuck Between Drum and TUBExploded View Exploded View of Control Panel & Dispenser Assembly Exploded View of Drum & TUB Assembly