LG Electronics F1256QD service manual Disassemble the Hall Sensor, Assemble the Hall Sensor

Page 31

1Disassemble the Hall Sensor

1) Disassemble the hook of Hall Sensor by (-) driver.

2) Pull up Hall Sensor slowly as shown in picture.

Caution

If you disassemble by force,not following the directions, the hooks of stator(red circled) might broke up.

Hence need change of stator assembly. So disassemble cautiously.

2 Assemble the Hall Sensor

1) Adjust the hole of Hall Sensor to	2) Push down the Hall sensor,
the hooks of stator as picture.(red circled)	and assemble to the hook for sure.

[Note]
Hall Sensor Part No.
• 24” / 25” : 6501KW2001A	• 27” : 6501KW2002A

30

Image 31

Contents Washing Machine No. MFL30574749 Contents F1*20TD1~9 / F1*22TD1~9/F1*56*D/WD-*690TDK SpecificationFeatures Features & Technical ExplanationWater Level Control Determine Washing Time by Fuzzy LogicDoor can not be Opened Drawer Door Lower cover Adjustable FeetPower Plug Parts IdentificationOpen the box and check appliance condition InstallationInstallation Check the conditions of installation areaConfirm the distance between the appliance and the wall Use spanner to remove transit boltsTap connection and hose connection must be parallel Connect Drain Hose Connect power plugStep Check the horizontality with a level GageTest operation Wash program selector Start/Pause button Tub CleanOperation OptionWater temperature selector Load Test ModeTime Delay & Beep ON/OFF Power buttonOption button Start/Pause buttonIntensive Rinse Spin Button Motor ChartPCB Layout Program Chart HOW to Know the Water Level Frequency TroubleshootingBefore Performing Service Load Test ModeError Symptom Cause Error DisplayWater Inlet Error IE Troubleshooting with ErrorUnbalanced Error UE How to disassemble and clean pump filter Water Outlet Error OEBind Drawer continuously? Over Flow Error FEPressure Sensor S/W Error PE Does the Door Switch operate as follows? Door Open Error dEMIN STD MAX Thermistor Heating Error tEMotor Locked Error LE Assemble the Hall Sensor Disassemble the Hall SensorNo Power Troubleshooting Without Error CodesVibration & Noise In Spin Detergent & Softener does not flow Water Leak from Dispenser Water LeakUnknown Water on Floor Control Panel Disassembly InstructionsDispenser Assembly Dispenser AssemblyLower Cover Door Inlet ValveGasket Assembly Common Rotor ASSEMBLY, Stator ASSEMBLY, Friction Damper AssemblyHeater PumpWhen Foreign Material is Stuck Between Drum and TUB Switch ASSEMBLY, Door LockExploded View Exploded View of Control Panel & Dispenser Assembly Exploded View of Drum & TUB Assembly