Error Display, Error Symptom Cause | LG Electronics F1256QD instruction

7-4. ERROR DISPLAY

If you press the [Start/Pause] button when an error in displayed, any error except software ERROR will disappear and the machine will change into pause status.

In case of , , , if the error is not resolved within 15 sec. In case of other errors, if the error is not resolved within 4 min. Power will be turned off automatically and the error only will be

blinked. But in the case of , power will not be turned off.

	ERROR	SYMPTOM	CAUSE

1	WATER INLET		Water has not reached to the pre-set level within 4 min.
	WATER INLET		since inlet valve operated, or water has not reached to
	ERROR		since inlet valve operated, or water has not reached to
	ERROR		the normal level within 25 min.	Page 21
			the normal level within 25 min.	Page 21

			The appliance is tilted.
2	UNBALANCED		Laundry is gathered to one side.
	ERROR		Non distributable things are put into the drum.	Page 22
			Non distributable things are put into the drum.	Page 22

3	WATER OUTLET		Water has not drained enough within 8 min.	Page 23
3	ERROR		Water has not drained enough within 8 min.	Page 23
	ERROR

4	OVERFLOW		Water is automatically being pumped out because too
4	ERROR		amuch water is in the tub.	Page 25
	ERROR		amuch water is in the tub.	Page 25

5	PRESSURE SENSOR		The sensor pressure switch is out of order.	Page 26
5	S/W ERROR		The sensor pressure switch is out of order.	Page 26
	S/W ERROR

6	DOOR OPEN		The [Start/Pause] button is pressed with the door open.
6	ERROR		The door switch is out of order.	Page 27
	ERROR		The door switch is out of order.	Page 27

7	THERMISTOR(HEATING)		The thermistor is out of order.	Page 28
7	ERROR		The thermistor is out of order.	Page 28
	ERROR

			PWB ASSEMBLY (Main) is out of order
8	CURRENT		Replace the PWB assembly (Main)
8	ERROR		Winding in the MOTOR is short-circuited.
	ERROR		Winding in the MOTOR is short-circuited.
			Replace the MOTOR

			The Connector (3-pin, male, white) in the wire harness
			is not connected to the Connector (3-pin, female, white)
			of MOTOR.
	MOTOR		Reconnect or repair the connector
	MOTOR		The electric contact between the connectors [3-pin,
9	LOCKED		male, white in the wire harness and 6-pin, female, white
	ERROR		in the PWB ASSEMBLY (Main]) is bad or unstable.
			Reconnect or repair the contact in the connector
			The wire harness between the MOTOR and PWB
			ASSEMBLY (Main) is cut (open circuited).
			The hall sensor is out of order/defective.	Page 29

10	POWER		The washer experienced a power failure.
10	FAILURE		The washer experienced a power failure.
	FAILURE

7-4. ERROR DISPLAY

ERROR

SYMPTOM

CAUSE

WATER INLET