INSTALLATION
REQUIREMENTS
Assemble the necessary tools and supplies before beginning the washer installation. The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
•Pliers (that open to 1%6 in. [39.5 mm])
•Flashlight (optional)
Tools needed for installation
•Open end wrench % in. (17 mm) and 1/2in. (13 mm)
•Level
•Wood block (2" x 4")
•Ruler or measuring tape
Parts supplied
C>
Beaded strap
0'£ ®ha
A pedestal may be purchased separately for this washer. This pedestal will add about 13 in. (33 cm) to the height of your unit for a total vertical height of approximately 51 in. (130 cm).
Optional Pedestal
This pedestal (with storage drawer) is available in three colors:
White- Part Number 42842
Bisque - Part Number 42844
Graphite - Part Number 42846
To order, call your local Sears store. For further information, please call
Transport bolt hole plug (4)
Parts listed are available from your local Sears store or Sears Service Center. For further information, please call
HOME ® (1-800-469-4663).
Selecting the proper location for your washer improves performance and minimizes noise and possible washer "walk."
Your washer can be installed under a custom counter, or in a basement, laundry room, closet, or recessed area. (See "Drain System.")
Companion appliance location requirements should also be considered. Proper installation is your responsibility.
You will need
• | A water heater | set to | deliver | 120°F (49°C) water to the |
| washer. |
|
|
|
• | A grounded electrical | outlet | located within 5 ft (1.5 m) of | |
| where the power cord is attached to the back of the washer. | |||
| (See "Electrical | Requirements.") | ||
If You Have
Laundry tub or standpipe taller than 96 in. (2.4 m)
Overhead sewer
Floor drain
You Will Need to Buy
Sump pump system (if not already available)
Standard 20 gal. (76 L), 30 in. (76.2 cm) tall drain tub or utility sink and sump pump (available from local plumbing suppliers)
Siphon break, Part Number 285834; additional drain hose Part Number
8318155; and connector kit, Part Number 285835
• Hot and cold water faucets located within 4 ft (1.2 m) of the | |
hot and cold water fill valves, and water pressure of | |
• A level floor with a maximum slope of 1 in. (2.5 cm) under | |
entire washer. Installing the washer on carpeting is not | |
recommended. |
|
• A sturdy and solid floor to | support the washer with a total |
weight (water and load) of | 400 Ibs (180 kg). |
Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures.
Drain hose too | Drain hose extension kit, | Part Number |
short | 285863 |
|
Water faucets | 2 longer water fill hoses: |
|
beyond reach of | 6 ft (1.8 m) Part Number | 76314, |
fill hoses | 10 ft (3.0 m) Part Number | 350008 |