Samsung DV209AE, DV209AG user manual Wire system connections

installing your dryer

3-WIRE system connections

1.Loosen or remove the center terminal block screw.

2.Connect the neutral wire (white or center wire) of the power cord to the center, silver-colored terminal screw of the terminal block. Tighten screw.

3.Connect the other wires to outer terminal block screws. Tighten screws.

4.Tighten the strain relief screws.

5.Insert the tab of the terminal block cover into your Dryer’s rear panel slot.

Secure the cover with a hold-down screw.

1. External ground connector 2. Neutral grounding wire (green/yellow) 3. Center silver-colored terminal block screw

4. Neutral wire (white or center wire)

5. 3/4” (1.9 cm) UL-listed strain relief

If converting from a 4-wire electrical system to a 3-wire, the ground strap must be

WARNING reconnected to the terminal block support to ground the Dryer frame to the neutral conductor.

4-WIRE system connections

1.Remove the center terminal block screw.

2.Connect the ground wire (green or unwrapped) of the power cord to the external ground conductor screw.

3.Connect the neutral wire (white or center wire) of the power cord and the appliance ground wire (green with yellow stripes) under the central screw of the terminal block.

4.Connect the other wires to the outer terminal block screws. Tighten screws.

5.Tighten the strain relief screws.

6.Insert the tab of the terminal block cover into your Dryer’s rear panel slot. Secure the cover with a hold-down screw.

1. External ground connector

2. Green or bare copper wire of power cord

3. 3/4 in. (1.9 cm) UL-listed strain relief

4. Center silver-colored terminal block screw

5. Grounding wire (green/yellow)

6. Neutral wire (white or center wire)

16_ installing your dryer

DV218AEW-02568A-02_EN.indd 16

2009-01-09 ¿ÀÀü 11:43:32