Electrolux 63742 VI manual Child safety lock

Page 11

Control panel 11

Display (7)

7.2

7.3

7.1

7.1Duration of selected programme :

After selecting a programme, the duration is displayed in hours and minutes (for example 2.05). The duration is calculated automatically on the basis of the maximum recommended load for each type of fabric. After the programme has started, the time remaining is updated every minute.

Alarm codes

In the event of operating problems, some alarm codes can be displayed, for example E20 (see chapter «What to do if...»).

End of programme

When the programme has finished a blinking zero 0 is displayed, the DOOR pilot light (10.2), the WASHING pilot light (10.1) and the pilot light of the button 8 go out and the door can be opened.

Incorrect option selection

If an option which is not compatible with the set wash programme is selected, the message Err is displayed for about 2 seconds and the yellow pilot light of the button 8 light starts blinking.

7.2Delay Start (7.2)

The selected delay (20 hours max) set by means of the relevant button appears on the display for about 3 seconds, then the duration of the previously selected programme is displayed.

The symbol 7.2 will appear on the display. The delay time value decreases by one unit every hour. When only 1 hour remains, the time decreases every minute.

7.3Child safety lock (7.3)

Image 11

Contents Lavamat 63742 Dear Customer Contents What to do if Technical Data Consumption value Packaging materials Old machine Ecological hints InstallationGeneral safety Safety informationPrior to using for the first time Installation Use Child SafetyDetergent dispenser drawer Compartment for prewash phase or stain removerProduct description Control panel Table of symbolsChild safety lock 10.1 10.2 Personalisation Acoustic signalsChild safety lock First UsePull out the dispenser drawer until it Daily UseLoad the laundry Measure out the detergent and the fabric softenerMachine is now switched on Select the Sensitive option Button Programme option buttonSelect the Prewash option Button Select the Stain option ButtonSelect the START/PAUSE Button Select the Delay Start ButtonSelect the Time option Button Interrupting a programme Select an additional rinseAltering an option or a running programme 10.2 go off and a blinking 0 will appear on the display Cancelling a programmeOpening the door after the programme has started At the end of the programmeBlouses Washing programmesNon-shrink shirts Spin Programme information Before loading the laundry TemperaturesPreparing the wash cycle Sorting out the laundryMaximum loads Laundry weightsFollowing weights are indicative Detergents and additives Removing stainsMarked before starting the wash programme Quantity of detergent to be usedDegrees of water hardness Powder detergents for delicate fabrics 60C max and woollensCare and cleaning Door seal Washing drumDrain pump Emergency emptying out Water inlet filterFrost precautions What to do if Possible cause/SolutionMachine fills then empties immediately Cause possible/Solution Consumption value Technical DataPolystyrene base from the bottom InstallationUnpacking Six smaller bolts C Water inlet Positioning and levellingWater drainage Water-stop deviceOnto a sink outlet spigot Green and Yellow Earth Blue Interest of the environmentElectrical connection With the following codePermanent connection Building-in Preparation and assembly of the doorMounting the door Hardwood strip Ecological hints Environment concernsPackaging materials Old machinePage 132 963 770-01-302008 Subject to change without notice