Electrolux 63742 VI manual First Use, Personalisation, Acoustic signals, Child safety lock

Page 13

Use 13

First Use

Ensure that the electrical and water connections comply with the installation instructions.

Remove the polystyrene block and any material from the drum.

Run a cotton cycle at 90° or 95°C, without any laundry in the machine, to remove any manufacturing residue from the drum and tub. Pour 1/2 a measure of detergent into the main wash compartment and start the machine.

Personalisation

Acoustic signals

The machine is provided with an acoustic device, which sounds in the following cases:

●at the end of the cycle

●if there is a fault

By pressing buttons 3 and 4 simultaneously for about 6 seconds, the acoustic signal is deactivated (except if there is a fault). By pressing these 2 buttons again, the acoustic signal is reactivated.

Child safety lock (7.3)

This function allows you to leave the appliance unsupervised without having the worry that children might be injured by or cause damage to the appliance.

This function remains able also when the washing machine is not working.

There are two different ways to set this option:

●before pressing the 8: it will be impossible to start the machine.

●after pressing the 8 it will be impossible to change any other programme or option.

To enable (disable) this option press buttons 4 and 5 simultaneously for about 6 seconds until the symbol 7.3 appears (disappears) on (from) the display.

Image 13

Contents Lavamat 63742 Dear Customer Contents What to do if Technical Data Consumption value Packaging materials Old machine Ecological hints InstallationPrior to using for the first time Safety informationGeneral safety Installation Use Child SafetyProduct description Compartment for prewash phase or stain removerDetergent dispenser drawer Control panel Table of symbolsChild safety lock 10.1 10.2 Child safety lock Acoustic signalsFirst Use PersonalisationLoad the laundry Daily UseMeasure out the detergent and the fabric softener Pull out the dispenser drawer until itMachine is now switched on Select the Prewash option Button Programme option buttonSelect the Stain option Button Select the Sensitive option ButtonSelect the Time option Button Select the Delay Start ButtonSelect the START/PAUSE Button Altering an option or a running programme Select an additional rinseInterrupting a programme Opening the door after the programme has started Cancelling a programmeAt the end of the programme 10.2 go off and a blinking 0 will appear on the displayNon-shrink shirts Washing programmesBlouses Spin Programme information Preparing the wash cycle TemperaturesSorting out the laundry Before loading the laundryFollowing weights are indicative Laundry weightsMaximum loads Detergents and additives Removing stainsDegrees of water hardness Quantity of detergent to be usedPowder detergents for delicate fabrics 60C max and woollens Marked before starting the wash programmeCare and cleaning Door seal Washing drumDrain pump Emergency emptying out Water inlet filterFrost precautions What to do if Possible cause/SolutionMachine fills then empties immediately Cause possible/Solution Consumption value Technical DataUnpacking InstallationPolystyrene base from the bottom Six smaller bolts C Water inlet Positioning and levellingWater drainage Water-stop deviceOnto a sink outlet spigot Electrical connection Interest of the environmentWith the following code Green and Yellow Earth BluePermanent connection Building-in Preparation and assembly of the doorMounting the door Hardwood strip Packaging materials Environment concernsOld machine Ecological hintsPage 132 963 770-01-302008 Subject to change without notice