Electrolux 63742 VI manual Permanent connection

Page 42

42Installation

If you fit your own plug, the colours of the wires in the mains lead of your appli- ance may not correspond with the markings identifying the terminals in your plug, proceed as follows:

Connect the green and yellow (earth) wire to the terminal in the plug which is

marked with the letter «E» or the earth symbol or coloured green and yellow.

Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black.

Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red.

The plug moulded on to the lead incorporates a fuse. For replacement, use a 13 Amp BS1363/A fuse. Only ASTA or BSI approved fuses should be used.

The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indi- cated by the coloured insert at the base of the plug.

A replacement cover/carrier must be obtained from your local AEG/ELECTROLUX Service Centre.

The power supply cable must be easily accessible after installing the machine.

Should the appliance power supply cable need to be replaced, this MUST be carried out by a Service Centre.

Permanent connection

In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.

The switch must not break the yellow and green earth cable at any point. This operation must be performed by a qualified electrician.

Image 42

Contents Lavamat 63742 Dear Customer Contents What to do if Technical Data Consumption value Installation Packaging materials Old machine Ecological hintsSafety information Prior to using for the first timeGeneral safety Installation Child Safety UseCompartment for prewash phase or stain remover Product descriptionDetergent dispenser drawer Table of symbols Control panelChild safety lock 10.1 10.2 First Use Acoustic signalsChild safety lock PersonalisationMeasure out the detergent and the fabric softener Daily UseLoad the laundry Pull out the dispenser drawer until itMachine is now switched on Select the Stain option Button Programme option buttonSelect the Prewash option Button Select the Sensitive option ButtonSelect the Delay Start Button Select the Time option ButtonSelect the START/PAUSE Button Select an additional rinse Altering an option or a running programmeInterrupting a programme At the end of the programme Cancelling a programmeOpening the door after the programme has started 10.2 go off and a blinking 0 will appear on the displayWashing programmes Non-shrink shirtsBlouses Spin Programme information Sorting out the laundry TemperaturesPreparing the wash cycle Before loading the laundryLaundry weights Following weights are indicativeMaximum loads Removing stains Detergents and additivesPowder detergents for delicate fabrics 60C max and woollens Quantity of detergent to be usedDegrees of water hardness Marked before starting the wash programmeCare and cleaning Washing drum Door sealDrain pump Water inlet filter Emergency emptying outFrost precautions Possible cause/Solution What to do ifMachine fills then empties immediately Cause possible/Solution Technical Data Consumption valueInstallation UnpackingPolystyrene base from the bottom Six smaller bolts C Positioning and levelling Water inletWater-stop device Water drainageOnto a sink outlet spigot With the following code Interest of the environmentElectrical connection Green and Yellow Earth BluePermanent connection Preparation and assembly of the door Building-inMounting the door Hardwood strip Old machine Environment concernsPackaging materials Ecological hintsPage 132 963 770-01-302008 Subject to change without notice