Electrolux 63742 VI manual What to do if, Possible cause/Solution

Page 32

32What to do if...

What to do if...

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.

During machine operation it is possible that the yellow pilot light of button 8 blinks, one of the following alarm codes appears on the display and at the same time some acoustic signals sound every 20 seconds to indicate that the machine is not working:

E10 : problem with the water supply

E20 : problem with the water draining

E40 : door open.

Once the problem has been eliminated, press the button 8 to restart the programme. If after all checks, the problem persists, contact your local Service Centre.

Problem

The washing machine does not start:

The machine does not fill:

Possible cause/Solution

The door has not been closed. E40

• Close the door firmly.

The plug is not properly inserted in the power socket.

• Insert the plug into the power socket.

There is no power at the socket.

• Please check your domestic electrical installation.

The main fuse or the fuse in the plug has blown.

• Replace the fuse.

The selector dial is not correctly positioned and the button 8 has not been depressed.

Please turn the selector dial and press the button 8 again.

The delay start has been selected.

If the laundry are to be washed immediately, cancel the delay start.

The CHILD SAFETY LOCK has been activated.

• Deactivated this device.

The water tap is closed. E10

• Open the water tap.

The inlet hose is squashed or kinked. E10

• Check the inlet hose connection.

The filter in the inlet hose is blocked.E10

• Clean the water inlet hose filter.

The door is not properly closed. E40

• Close the door firmly.

Image 32
Contents Lavamat 63742 Dear Customer Contents What to do if Technical Data Consumption value Installation Packaging materials Old machine Ecological hintsGeneral safety Safety informationPrior to using for the first time Installation Child Safety UseDetergent dispenser drawer Compartment for prewash phase or stain removerProduct description Table of symbols Control panelChild safety lock 10.1 10.2 Acoustic signals Child safety lockFirst Use PersonalisationDaily Use Load the laundryMeasure out the detergent and the fabric softener Pull out the dispenser drawer until itMachine is now switched on Programme option button Select the Prewash option ButtonSelect the Stain option Button Select the Sensitive option ButtonSelect the START/PAUSE Button Select the Delay Start ButtonSelect the Time option Button Interrupting a programme Select an additional rinseAltering an option or a running programme Cancelling a programme Opening the door after the programme has startedAt the end of the programme 10.2 go off and a blinking 0 will appear on the displayBlouses Washing programmesNon-shrink shirts Spin Programme information Temperatures Preparing the wash cycleSorting out the laundry Before loading the laundryMaximum loads Laundry weightsFollowing weights are indicative Removing stains Detergents and additivesQuantity of detergent to be used Degrees of water hardnessPowder detergents for delicate fabrics 60C max and woollens Marked before starting the wash programmeCare and cleaning Washing drum Door seal Drain pump Water inlet filter Emergency emptying outFrost precautions Possible cause/Solution What to do ifMachine fills then empties immediately Cause possible/Solution Technical Data Consumption valuePolystyrene base from the bottom InstallationUnpacking Six smaller bolts C Positioning and levelling Water inletWater-stop device Water drainageOnto a sink outlet spigot Interest of the environment Electrical connectionWith the following code Green and Yellow Earth BluePermanent connection Preparation and assembly of the door Building-inMounting the door Hardwood strip Environment concerns Packaging materialsOld machine Ecological hintsPage 132 963 770-01-302008 Subject to change without notice