Electrolux 63742 VI manual Water inlet filter, Emergency emptying out

Page 30

30Care and cleaning

replacing the cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it.

Water inlet filter

If you notice that the machine is taking

longer to fill, check that the filter in the water inlet hose is not blocked.

1.Turn off the water tap.

2.Unscrew the hose from the tap.

3.Clean the filter in the hose with a stiff brush.

4. Screw the hose back onto the tap.

Emergency emptying out

If the water is not discharged, proceed as follows to empty out the machine:

1. pull out the plug from the power socket;

2. close the water tap;

3. if necessary, wait until the water has cooled down;

4.place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Empty the bowl. Repeat the procedure until water stops flowing out;

5.clean the pump if necessary as previously described;

6.replace the emergency emptying hose in its seat after having plugged it;

7.refit the pump cover.

Image 30

Contents Lavamat 63742 Dear Customer Contents What to do if Technical Data Consumption value Installation Packaging materials Old machine Ecological hintsSafety information Prior to using for the first timeGeneral safety Installation Child Safety UseCompartment for prewash phase or stain remover Product descriptionDetergent dispenser drawer Table of symbols Control panelChild safety lock 10.1 10.2 First Use Acoustic signalsChild safety lock PersonalisationMeasure out the detergent and the fabric softener Daily UseLoad the laundry Pull out the dispenser drawer until itMachine is now switched on Select the Stain option Button Programme option buttonSelect the Prewash option Button Select the Sensitive option ButtonSelect the Delay Start Button Select the Time option ButtonSelect the START/PAUSE Button Select an additional rinse Altering an option or a running programmeInterrupting a programme At the end of the programme Cancelling a programmeOpening the door after the programme has started 10.2 go off and a blinking 0 will appear on the displayWashing programmes Non-shrink shirtsBlouses Spin Programme information Sorting out the laundry TemperaturesPreparing the wash cycle Before loading the laundryLaundry weights Following weights are indicativeMaximum loads Removing stains Detergents and additivesPowder detergents for delicate fabrics 60C max and woollens Quantity of detergent to be usedDegrees of water hardness Marked before starting the wash programme Care and cleaning Washing drum Door sealDrain pump Water inlet filter Emergency emptying outFrost precautions Possible cause/Solution What to do ifMachine fills then empties immediately Cause possible/Solution Technical Data Consumption valueInstallation UnpackingPolystyrene base from the bottom Six smaller bolts C Positioning and levelling Water inletWater-stop device Water drainageOnto a sink outlet spigot With the following code Interest of the environmentElectrical connection Green and Yellow Earth BluePermanent connection Preparation and assembly of the door Building-inMounting the door Hardwood strip Old machine Environment concernsPackaging materials Ecological hintsPage 132 963 770-01-302008 Subject to change without notice