Electrolux 63742 VI manual Select an additional rinse, Altering an option or a running programme

Page 18

18Use

Selecting the delayed start.

●Select the programme and the required options.

●Select the delay start.

●Depress button 8: the machine starts its hourly countdown. The programme will start after the selected delay has expired.

Cancelling the delayed start

●set the washing machine to PAUSE by pressing the button 8;

●press button 9 once until the symbol 0’ is displayed;

●press the button 8 again to start the programme.

Important!

●The selected delay can be changed only after selecting the washing programme again.

The button 9 can not be selected with DRAIN programme.

Select an additional rinse

This appliance is designed for saving water. However, for people with a very delicate skin (allergic to detergents) it may be necessary to rinse the laundry using an extra quantity of water (extra rinse).

Press buttons 2 and 3 simultaneously for some seconds: the pilot light 10.3 comes on. This function stays permanently on. To remove it press the same but- tons again until the pilot light 10.3 goes off.

Altering an option or a running programme

It is possible to change some options before the programme carries it out. Before you make any change, you must pause the washing machine by pressing the button 8. Changing a running programme is possible only by resetting it. Turn the programme selector dial to O and then to the new programme position. Start the new programme by pressing the button 8 again. The washing water in the tub will not be emptied out.

Interrupting a programme

Press button 8 to interrupt a programme which is running, the corresponding light starts blinking. Press the button again to restart the programme.

Image 18

Contents Lavamat 63742 Dear Customer Contents What to do if Technical Data Consumption value Installation Packaging materials Old machine Ecological hintsSafety information Prior to using for the first timeGeneral safety Installation Child Safety UseCompartment for prewash phase or stain remover Product descriptionDetergent dispenser drawer Table of symbols Control panelChild safety lock 10.1 10.2 First Use Acoustic signalsChild safety lock PersonalisationMeasure out the detergent and the fabric softener Daily UseLoad the laundry Pull out the dispenser drawer until it Machine is now switched on Select the Stain option Button Programme option buttonSelect the Prewash option Button Select the Sensitive option ButtonSelect the Delay Start Button Select the Time option ButtonSelect the START/PAUSE Button Select an additional rinse Altering an option or a running programmeInterrupting a programme At the end of the programme Cancelling a programmeOpening the door after the programme has started 10.2 go off and a blinking 0 will appear on the displayWashing programmes Non-shrink shirtsBlouses Spin Programme information Sorting out the laundry TemperaturesPreparing the wash cycle Before loading the laundryLaundry weights Following weights are indicativeMaximum loads Removing stains Detergents and additivesPowder detergents for delicate fabrics 60C max and woollens Quantity of detergent to be usedDegrees of water hardness Marked before starting the wash programmeCare and cleaning Washing drum Door sealDrain pump Water inlet filter Emergency emptying outFrost precautions Possible cause/Solution What to do ifMachine fills then empties immediately Cause possible/Solution Technical Data Consumption valueInstallation UnpackingPolystyrene base from the bottom Six smaller bolts C Positioning and levelling Water inletWater-stop device Water drainageOnto a sink outlet spigot With the following code Interest of the environmentElectrical connection Green and Yellow Earth BluePermanent connection Preparation and assembly of the door Building-inMounting the door Hardwood strip Old machine Environment concernsPackaging materials Ecological hintsPage 132 963 770-01-302008 Subject to change without notice