Installation 39
4.Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the appliance.
Installation should comply with local water authority
and building regulations requirements. A minimum water pressure of 0.05 MPa is required for safe operation of the appliance.
If you cannot make the cold water connection direct from the rising mains, you may be able to operate the
appliance from your cold water storage system. There
should be a minimum vertical distance of 5.02m (16.5ft) between the appliance’s inlet and the bottom of the water storage tank.
Water-stop device
The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in the window “A”. Should this occur, turn the water tap off and refer to your Service Centre to replace the hose.
A
352
Water drainage
This appliance is designed to be permanently plumbed into your home's drainage system using one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using the “U” piece” supplied.
“U” piece supplied
Place the drain hose into your standpipe, which should have an internal diameter of approximately 38mm thus ensuring
there is an air break between the drain hose and standpipe.
P1199
38 mm (1.5”)
standpipe diameter
30 cm (12")