Electrolux 63742 VI manual Mounting the door

Page 44

44Installation

c) Mounting the door

Fix the hinges (1) to the machine by means of the M5x15 screws (3-Fig. B). The hinges can be adjusted to compensate for possible uneven thickness of the door. To align the door perfectly it is necessary to loosen the screw (3-Fig. B), adjust the door and tighten the screw again.

d) Counter-magnet (6)

The appliance is pre-arranged for a magnetic clo-

sure of the door. To enable a correct operation of6 this device, it is necessary to screw the counter-

magnet (6) (steel disk + rubber ring) into the inner side of the door.

Its position must correspond to the magnet (4) on the appliance (see picture D).

4

If the door has to be opened from left to right, invert the position of the plates (7), the magnet

(4)and the plate (5) (Fig. B and E). Mount the countermagnet (6) and the hinges (1) as previously described.

D

4

57

E 3

8

6

1

8

2

Recommendations regarding the construction and fitting of a base when the installation requires an integrated appliance to be raised

Where the appliance has been raised by mounting onto a wooden base provided by the installer. The material used to construct the base should have a non slip surface, be water repellent and if possible be one solid piece.

If it is not possible to use one solid piece, due to the additional height required, ensure that any additional strips of timber are glued and screwed to the underside of the base

(see Fig.F).

Drill four fixing holes see Fig. G

	600-605 mm
	490 mm
	95 mm
	Front edge
	50 mm
G	Top view
G

Image 44

Contents Lavamat 63742 Dear Customer Contents What to do if Technical Data Consumption value Installation Packaging materials Old machine Ecological hintsGeneral safety Safety informationPrior to using for the first time Installation Child Safety UseDetergent dispenser drawer Compartment for prewash phase or stain removerProduct description Table of symbols Control panelChild safety lock 10.1 10.2 Acoustic signals Child safety lockFirst Use PersonalisationDaily Use Load the laundryMeasure out the detergent and the fabric softener Pull out the dispenser drawer until itMachine is now switched on Programme option button Select the Prewash option ButtonSelect the Stain option Button Select the Sensitive option ButtonSelect the START/PAUSE Button Select the Delay Start ButtonSelect the Time option Button Interrupting a programme Select an additional rinseAltering an option or a running programme Cancelling a programme Opening the door after the programme has startedAt the end of the programme 10.2 go off and a blinking 0 will appear on the displayBlouses Washing programmesNon-shrink shirts Spin Programme information Temperatures Preparing the wash cycleSorting out the laundry Before loading the laundryMaximum loads Laundry weightsFollowing weights are indicative Removing stains Detergents and additivesQuantity of detergent to be used Degrees of water hardnessPowder detergents for delicate fabrics 60C max and woollens Marked before starting the wash programmeCare and cleaning Washing drum Door sealDrain pump Water inlet filter Emergency emptying outFrost precautions Possible cause/Solution What to do ifMachine fills then empties immediately Cause possible/Solution Technical Data Consumption valuePolystyrene base from the bottom InstallationUnpacking Six smaller bolts C Positioning and levelling Water inletWater-stop device Water drainageOnto a sink outlet spigot Interest of the environment Electrical connection With the following code Green and Yellow Earth BluePermanent connection Preparation and assembly of the door Building-inMounting the door Hardwood strip Environment concerns Packaging materialsOld machine Ecological hintsPage 132 963 770-01-302008 Subject to change without notice