Electrolux 63742 VI manual Positioning and levelling, Water inlet

Page 38

38Installation

Positioning and levelling

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc.

Before placing it on small tiles, apply a rubber coating.

Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.

If it is impossible to avoid positioning the machine next to a gas cooker or coal-burning stove, an insulating panel covered with aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances.

The machine must not be installed in rooms where the temperature can drop below 0.

The water inlet hose and the drain hose must not be kinked.

Please ensure that when the appliance is installed, it is easily accessible for the engineer in the event of a breakdown.

Carefully level by screwing the adjustable feet in or out. After having levelled the machine, tighten the lock nuts.

Water inlet

An inlet hose is supplied and can be found inside the machine drum.

Do not use the hose from your previous machine to connect to the water supply.

This appliance must be connected to a cold water supply.

1.Open the porthole and extract the inlet hose.

2.Connect the hose with the angled connection to the machine.

Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap.

3.Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

HEC0006

Image 38

Contents Lavamat 63742 Dear Customer Contents What to do if Technical Data Consumption value Installation Packaging materials Old machine Ecological hintsGeneral safety Safety informationPrior to using for the first time Installation Child Safety UseDetergent dispenser drawer Compartment for prewash phase or stain removerProduct description Table of symbols Control panelChild safety lock 10.1 10.2 First Use Acoustic signalsChild safety lock PersonalisationMeasure out the detergent and the fabric softener Daily UseLoad the laundry Pull out the dispenser drawer until itMachine is now switched on Select the Stain option Button Programme option buttonSelect the Prewash option Button Select the Sensitive option ButtonSelect the START/PAUSE Button Select the Delay Start ButtonSelect the Time option Button Interrupting a programme Select an additional rinseAltering an option or a running programme At the end of the programme Cancelling a programmeOpening the door after the programme has started 10.2 go off and a blinking 0 will appear on the displayBlouses Washing programmesNon-shrink shirts Spin Programme information Sorting out the laundry TemperaturesPreparing the wash cycle Before loading the laundryMaximum loads Laundry weightsFollowing weights are indicative Removing stains Detergents and additivesPowder detergents for delicate fabrics 60C max and woollens Quantity of detergent to be usedDegrees of water hardness Marked before starting the wash programmeCare and cleaning Washing drum Door sealDrain pump Water inlet filter Emergency emptying outFrost precautions Possible cause/Solution What to do ifMachine fills then empties immediately Cause possible/Solution Technical Data Consumption valuePolystyrene base from the bottom InstallationUnpacking Six smaller bolts C Positioning and levelling Water inletWater-stop device Water drainageOnto a sink outlet spigot With the following code Interest of the environmentElectrical connection Green and Yellow Earth BluePermanent connection Preparation and assembly of the door Building-inMounting the door Hardwood strip Old machine Environment concernsPackaging materials Ecological hintsPage 132 963 770-01-302008 Subject to change without notice